Acid-Etched Fracture Conductivity with In Situ-Generated Acid in Ultra-Deep, High-Temperature Carbonate Reservoirs.

In situ-generated acid is commonly employed in ultra-deep, high-temperature carbonate reservoirs during acid fracturing to increase the effective acid penetration distance. However, the variation pattern of acid-etched fracture conductivity with in situ-generated acid has not been systematically studied. This paper investigates the evolution of the conductivity of primary and secondary fractures through a series of experiments involving in situ acid displacement and acid-etched fracture conductivity measurement. Based on the experimental results, a calculation model for the conductivity of acid-etched fractures with in situ-generated acid was established. The study indicates that after acid etching, rough particulate points and grooved dissolution patterns form on the surfaces of primary and secondary fractures, respectively. The dissolution volume in primary fractures is greater than that in secondary fractures, with both showing a linear increase over time. Due to the presence of dissolution grooves on the surfaces of secondary fractures, their conductivity is higher than that of primary fractures under the same acid–rock contact time. The conductivity of both primary and secondary fractures increases with the acid–rock contact time. However, beyond approximately 70 min of contact time, the conductivity of primary fractures shows no significant increase. The conductivity of primary and secondary fractures with in situ-generated acid is slightly lower than that with gelled acid under the same contact time, but significantly higher than that with crosslinked acid. This study provides guidance for the design and parameter optimization of acid fracturing in ultra-deep, high-temperature carbonate reservoirs. [ABSTRACT FROM AUTHOR]