Ceramic Nanotubes—Conducting Polymer Assemblies with Potential Application as Chemosensors for Breath Ammonia Detection in Chronic Kidney Disease.

This paper describes the process of producing chemosensors based on hybrid nanostructures obtained from Al₂O₃, as well as ZnO ceramic nanotubes and the following conducting polymers: poly(3-hexylthiophene), polyaniline emeraldine-base (PANI-EB), and poly(3, 4-ethylenedioxythiophene)-polystyrene sulfonate. The process for creating ceramic nanotubes involves three steps: creating polymer fiber nets using poly(methyl methacrylate), depositing ceramic films onto the nanofiber nets using magnetron deposition, and heating the nanotubes to 600 °C to burn off the polymer support completely. The technology for obtaining hybrid nanostructures from ceramic nanotubes and conducting polymers is drop-casting. AFM analysis emphasized a higher roughness, mainly in the case of PANI-EB, for both nanotube types, with a much larger grain size dimension of over 5 μm. The values of the parameter Rku were close or slightly above 3, indicating, in all cases, the formation of layers predominantly characterized by peaks and not by depressions, with a Gaussian distribution. An ink-jet printer was used to generate chemiresistors from ceramic nanotubes and PANI-EB structures, and the metallization was made with commercial copper ink for printed electronics. Calibration curves were experimentally generated for both sensing structures across a wider range of NH₃ concentrations in air, reaching up to 5 ppm. A 0.5 ppm detection limit was established. The curve for the ZnO:PANI-EB structure presented high linearity and lower resistance values. The sensor could be used in medical diagnosis for the analysis of breath ammonia and biomarkers for predicting CKD in stages higher than 1. The threshold value of 1 ppm represents a feasible value for the presented sensor, which can be defined as a simple, low-value and robust device for individual use, beneficial at the patient level. [ABSTRACT FROM AUTHOR]