Analysis of Wear Resistance of Metallic-Reinforced Polyurethane Resin Composites for Sheet Metal Forming.

The paper presents the results of testing the wear resistance and coefficient of friction (COF) tools made of SikaBeresin® F50 polyurethane resin intended for dies and punches for the cold sheet metal forming process. Seven sets of composite tools (rotating rings) additionally reinforced with waste metallic powders from Al and Cu alloys (5-20% by volume) from the dry cutting process of pipes and rods were tested. Wear resistance tests and determination coefficient of friction were carried out using the T-05 block-on-ring tribotester. The tests were performed for heat and corrosion resistant sheets made of nickel alloy AMS5599 (Inconel 625), iron alloy AMS5510 (321) and aluminum alloy sheets AMS4026 (6061-T4). Composite tools with the addition of 20% aluminum powder (A+B+C+20%Al) tested with a specimen of steel alloy AMS5510 and nickel alloy AMS5599 were characterized by the lowest wear resistance. In each case, the composite rotating ring without reinforcements was characterized by the lowest coefficient of friction. The use of Cu powder reinforcements in each case had a positive effect on increasing wear resistance. The best wear resistance of 0.011% was obtained for composite rotating ring with the addition of 10% copper powder paired with specimen of nickel alloy AMS5599 sheet. [ABSTRACT FROM AUTHOR]