Deposition of W Nanoparticles by Magnetron Sputtering Gas Aggregation Using Different Amounts of H 2 /Ar and Air Leaks.

This work presents the synthesis of tungsten nanoparticles (W NPs) using a cluster source based on magnetron sputtering combined with gas aggregation (MSGA), operated with up to 81% H₂ in the hydrogen/argon mixture used as a working gas. The results show that, with up to 41% H₂ in discharge, the synthesis rate increases by more than 60 times, rapidly decreasing for over 50% H₂ in discharge. The W dust is still produced for H₂-dominated discharges (81%), and its deposition rate is small but not negligible (0.02 mg/h). The obtained W NPs are isolated, with the diameter decreasing from 50 nm to 15 nm when the amount of H₂ in discharge is smaller than 41%. Over this value, the particles tend to agglomerate, forming structures similar to film-like deposits. Also, the diameter of the dust spots deposited on substrates depends on the H₂ content of the discharge. This allows the efficient coating of substrates up to 26 mm wide by translating them in front of the MSGA cluster source exit aperture. Additionally, for 41% H₂ in discharge, the influence of synthetic air leaks (0%–8.2%) in discharge was investigated. The deposition rate decreases rapidly (ceasing for around 6% air in discharge), and the obtained nanoparticles tend to agglomerate on the substrate (at 3.3% air content, the dust deposit has the aspect of a near-continuous film). Chemical composition investigations show a pronounced tendency for oxidation, nitridation, and oxynitride formation in the presence of air leaks. [ABSTRACT FROM AUTHOR]