Design of CRLH-TL BPF with controllable attenuation poles.

Compact and pole-controllable resonators and bandpass filter (BPF) using a composite right/left-handed transmission line (CRLH-TL) are designed in this study. The distributed constant line in the CRLH-TL has applied a tap-coupling technique, and one tap-coupled stub is loaded with the left-handed (LH) circuit. Attenuation poles are generated when the input susceptance of the stub diverges. In the tap-coupled CRLH-TL resonator, the attenuation pole is controlled at either the desired lower or higher region frequency than a resonant frequency by adjusting the circuit parameters. Also, the BPF constructed by the CRLH-TL resonators is designed based on a filter design theory, where the attenuation poles are located at lower and higher region frequencies than a negative-first-order frequency. The BPF with microstrip structure is fabricated using MEGTRON6 R-5775 ( ε r : 3.7, h: 0.63 mm, t: 18 μm), chip capacitors, and wire inductors. The simulated results show that the desired characteristics are approximately satisfied, i.e., we can design the CRLH-TL BPF which is controllable for the attenuation poles at both lower and higher region frequencies than a resonant frequency. The measured results are good agreement with the simulation. The negative-first-order frequency is generated at 2.00 GHz with 133 MHz bandwidth, i.e., the fractional bandwidth is 6.65 %. The resonator lengths in the BPF are shortened by 81.5 % and 75.0 % in comparison with a conventional half-wavelength ( λ / 2 ) openstub, and the size of the fabricated BPF is 0.18 λ g × 0.17 λ g . Therefore, a compact BPF with two controllable attenuation poles is realized by the tap-coupled CRLH-TL. [ABSTRACT FROM AUTHOR]