Optimization of microencapsulation of polyaspartic acid ester into UV curable epoxy‐acrylate resin using Taguchi method of experimental design.

Due to fast reaction with isocyanates, polyaspartic acid esters (PAAE) can be used for the development of microcapsules for self‐healing coatings. Microcapsules with encapsulated PAAE into shell formed by UV‐cured commercial epoxy‐acrylate resin were produced through oil‐in‐water emulsion polymerization triggered by UV light. The obtained microcapsules were characterized by FTIR, TGA, optical microscopy, and SEM. Various encapsulation parameters, including core to shell ratio, agitation speed, emulsifier type and concentration, solvent type and its concentration in the oil phase, have been selected at four different levels. Microencapsulation was optimized using Taguchi L16 parameter design approach for determination of desired outcome as larger is better (maximal core content) and nominal is better (microcapsule diameter of 50 μm). It was determined that conditions to prepare microcapsules with the highest core content and the microcapsule size close to 50 μm are rather similar requiring core‐to‐shell ratio at about 4:1, low agitation speed of 500–1000 rpm, and the use of two polymeric emulsifiers poly(vinyl alcohol) and Gum Arabic at concentration of about 2%. Primary benefits of UV‐induced shell formation during microencapsulation of active compounds are remarkably shorter time of the process and possibilities to reach high core content and prepare microcapsules of desirable size. [ABSTRACT FROM AUTHOR]