Investigation of Mechanical and Physical Features of Cementitious Jet Grout Applications for Various Soil Types.

The cementitious jet grout method (CJG) is one of the most preferred methods for the ground reinforcement of building foundations. As a result of the soil improvement made with the CJG, it was observed that there was a decrease in settlement, permeability, and liquefaction potential and an increase in the bearing capacity. In this study, columns with different grouting pressures (400, 450, and 500 bar) and water/cement ratios of 0.75, 1.00, and 1.25 were produced on several soil types (sand, clay, and alluvial soil) that have high liquefaction, settlement potential, and low bearing capacity. CJG columns were kept for 28 days after completion and then removed from the soil, and diameter measurements were made and significant differences were observed according to pressure and w/c ratios. Three samples were taken in CJG columns extracted from the ground. Laboratory tests were conducted to determine the physical (water absorption rate, density, and porosity) and mechanical (UCS and UPV) properties of CJG column samples. The highlighting of this paper is to build full-scale CJG columns in sandy soil, clay soil, and alluvial soil, increase the geotechnical engineering properties, and investigate the strength development, and diameter under different w/c ratios and different injection pressures. The strength of CJG columns in sandy soils was found between 36 and 15 MPa, in clay soils between 15 and 4 MPa and in alluvial soils between 32 and 15 MPa. Moreover, it was observed that there was a significant increase in the diameters with the increase in the injection pressure and a decrease in the compressive strengths. When the CJG column diameters were compared with constant injection pressure and increasing w/c ratios, the maximum increase was found to be 13% for sandy soils, 10% for clayey soils, and 14% for alluvial soils. The column diameters were 37% larger for sandy soils than clayey soils and 26% larger than alluvial soils at the same w/c ratio and constant injection pressure. In conclusion, since the results found in this study were made on a real scale in the field and for three different soil conditions, the results can be used directly in future engineering applications. [ABSTRACT FROM AUTHOR]