The Effects of Corrugated Steel Fiber on the Properties of Ultra-High Performance Concrete of Different Strength Levels.

This article describes the influence of corrugated steel fiber on the mechanical properties and fracture energy of Ultra-High Performance Concretes (UHPC) of various strength levels. Three UHPC formulations with compressive strengths of 143, 152, and 177 MPa were tested. The following parameters for the formulations without fiber and those containing 2% steel fiber by volume were determined: compressive strength, splitting tensile strength, flexural strength, modulus of elasticity, Poisson's ratio and critical stress intensity factor. From the axial tensile test results, the following parameters were obtained: the cracking stress, tensile strength, and fracture energy of Ultra-High Performance Fiber Reinforced Concrete (UHPFRC) of different strength levels. With the introduction of steel fiber, an increase in all the investigated parameters is observed regardless of the strength of the concrete matrix. The most remarkable influence the fiber has on the splitting tensile strength, flexural strength and critical stress intensity coefficient, the increase is up to 1.6–3.2 times. There was a slight increase in compressive strength and elastic modulus—up to 5.0–7.4% depending on the composition. Poisson's ratio was equal to 0.2 regardless of the strength of the concrete matrix and the presence of steel fiber. Based on the test results, equations were proposed to predict the properties of UHPC and UHPFRC depending on the water–cement ratio, silica fume content, cement compressive strength and the volumetric content of corrugated steel fiber. The calculated and experimental values showed good convergence with a correlation coefficient in the range of 0.885–0.997. [ABSTRACT FROM AUTHOR]