9.9 µW, 140 dB DR, and 93.27 dB SNDR, Double Sampling ΔΣ Modulator Using High Swing Inverter-Based Amplifier for Digital Hearing Aids.

In this paper, an ultra-low-power second-order, single-bit discrete-time (DT) double sampling ΔΣ modulator was proposed for hearing aid applications. In portable biomedical devices that are permanently used such as hearing aids, short battery lifetime and power dissipation are considerable issues. In a typical delta–sigma modulator, the most power-consuming parts are the operational transconductance amplifiers (OTAs), and their elimination without loss of efficiency is now challenging. This proposed modulator includes an ultra-low-power self-biased inverter-based amplifier with swing enhancement instead of power-hungry OTAs. Low voltage amplifier design reduces output swing voltage, affecting delta–sigma modulator efficiency and decreasing the signal-to-noise and distortion ratio (SNDR) and dynamic range (DR) values. In this article, the proposed amplifier's source and tail transistors were biased in the sub-threshold region, increasing the output swing voltage significantly and leading to desired properties for a hearing aid modulator. The proposed amplifier peak-to-peak swing voltage was approximately 1.01 V at a 1 V power supply. In addition, the proposed modulator design used a standard 180 nm CMOS technology, which obtained 140 dB DR and 93.27 dB SNDR for a 10 kHz signal bandwidth with an oversampling ratio (OSR) of 128. Finally, the modulator's effective chip area was 0.02 mm² and consumed only about 9.9 µW, while the figure of merit (FOM_W) and FOMs achieved 1.31 fJ/step and 183.31, respectively. [ABSTRACT FROM AUTHOR]