The Annealing Effect of Welding on the Strength of Cold‐worked Stainless Steel.

Cold‐working can occur during the production of flat sheet products and the fabrication of structural cross‐sections. In both cases, when the material is cold‐worked, plastic deformations result in material strength enhancements. These strength enhancements are particularly significant for materials such as stainless steel, which exhibit rounded stress‐strain behaviour and pronounced strain hardening, and for hollow cross‐sections, where the strength increases arise in both the corner and flat regions of the cross‐section. Numerous studies have shown the importance of utilising this strength enhancement in design, and expressions to predict the strength enhancements have been established. However, if cold‐worked material is welded, some enhanced strength can be lost due to partial annealing in the heat affected zone (HAZ). The extent of this strength loss is investigated experimentally herein. The experimental programme comprised ten tensile coupon tests, with central welds parallel and transverse to the direction of cold‐rolling, as well as twelve full cross‐section tensile tests. Digital imaging correlation was utilised to determine the local constitutive properties of the base metal, the HAZ, and the weld metal. The microhardness and microstructure of the welded coupons, along with the widths of the weld and HAZ, were also characterised. [ABSTRACT FROM AUTHOR]