Comparison of the geometric accuracy of holes made in CFRP/Ti laminate by drilling and helical milling.

Laminates of carbon fibre reinforced polymer (CFRP) and titanium (Ti) alloy are used in aerospace applications and require holes for joining to other components, which can weaken them. In this study, to determine the influences of drilling and helical milling on the geometric accuracy of holes, holes were made in a CFRP/Ti-laminated structure by these two techniques, and variations in aperture and roundness at different positions were investigated. In two processes, apertures are larger in the middle and smaller at the ends, and most are larger than the apertures of standard holes (6 mm). With drilling, roundness is relatively high at hole entrances and exits. In helical milling, the maximum roundness occurs just underneath the hole entrance, while the minimum occurs at the exit. In the drilling of Ti alloy, the maximum aperture occurs at the entrance; however, with helical milling, the hole entrance aperture is smaller. The aperture at other positions is relatively small. During drilling, the maximum roundness occurs at hole entrances, while the minimum occurs just underneath and then increases with depth. Helical milling produces a relatively large roundness at hole entrances, with consistent variation in other positions. Generally, helical milling of a laminated structure produces better geometric accuracy in holes in the Ti alloy layer, better hole roundness in the CFRP layer, and smaller roundness in the transition zone. However, drilling achieves better aperture accuracy in CFRP and smaller aperture errors in the transition zone. These results will help to produce stronger CFRP/Ti-laminated structures. [ABSTRACT FROM AUTHOR]