Study on cutting burr and tool failure during high-speed milling of compacted graphite iron by the coated carbide tool.

Compacted graphite iron (CGI) is considered as the ideal material to make modern fuel-efficient diesel engine. Due to the vermicular or worm-like graphite distributed among the ferrite/pearlite matrix, CGI behaves better physical and mechanical properties in comparison with gray cast iron (GCI) and spherical graphite spheroidal cast iron (SGI). However, these good properties bring about the machining challenges. So it is important to appropriately select cutting parameters to machine this material with economy and efficiency. The present study investigated the influence of cutting parameters, such as cutting speed V, feed rate f, and exit angle Ψ, on workpiece material removal volume Q and cutting burr height on the entrance side H₁ and on the exit side H₂ during high-speed milling of CGI by the coated carbide tools_. On this basis, the relatively optimum high-speed cutting parameters were selected under the research condition. Cutting tool failure mechanism was also investigated with the aid of scanning electronic microscope (SEM) and energy-dispersive system (EDS) (SUPRA55, Germany) analysis. The results showed that Q, H₁, H₂, and the type of cutting burr on the exit side of the machined surface could be influenced by the cutting parameters. And the relatively optimum cutting parameters are V = 800 m/min, f = 0.25 mm/rev, and Ψ = 60°. Adhesive wear and thermal cracks which were perpendicular to the cutting edge were common wear mechanisms during the cutting process. However, with an increase in feed rate, mechanical cracks which were parallel to the cutting edge could be found on the flank face of the cutting tool. [ABSTRACT FROM AUTHOR]