Mechanical and physical screw withdrawal properties behavior of agglomerated panels reinforced with coir and pejibaye fibers.

The screw withdrawal resistance and the mechanical behavior of agglomerated panels reinforced with coir and pejibaye fibers were evaluated using through and non-through screw withdrawal tests. Widespread commercially materials, such as Pinus solid wood, Medium Density Fiberboard (MDF) and plywood, were also tested in order to compare the behavior and results obtained with the lignocellulosic-reinforced agglomerated panels. Among the conventional materials tested, the highest maximum withdrawal load/thickness ratio was measured in solid wood. Panels reinforced with natural fibers showed lower withdrawal resistance than conventional materials. However, panels reinforced with coir fibers reached about 74% of the maximum strength achieved by MDF samples. Panels reinforced with pejibaye showed the worst mechanical performance. Hybridization between pejibaye and coir fibers resulted, however, in a performance improvement of approximately 50% in the maximum withdrawal load comparing with panels reinforced only with pejibaye fibers. The behavior along screw withdrawal was analyzed and could be split into four different steps. Each of these steps was correlated to the screw withdrawal rate, and also with the interactions between the material and the screw. The mechanisms involved in each step are presented and discussed. [ABSTRACT FROM AUTHOR]