The physical characteristics of anaerobic granular sludges in relation to their internal architecture.

A range of granular sludges was taken from industrial anaerobic sludge blanket reactors treating a wide variety of wastewaters and a comparison was made between the polymers which were extractable from the granules and their internal structures. The study of the internal structure, using sequential staining of ultra-thin sections, showed the complexity of granular sludges. Much of the area was occupied by Gram-negative cells and the area which stained positive for protein was found to increase nearer the centre of the granules. This was accompanied by a decrease in the carbohydrate positive areas. Positive areas for lipid were widespread throughout the granules. Changes in the internal structure were observed when the type of wastewater treated by the granules was changed and a comparison between sludges treating the same type of wastewater showed that factors other than the nature of the substrate must be considered as parameters which will affect the structure of the granules. Although an appreciable variation in the granule strengths was noted, it was not possible to relate these differences, on an overall basis, to either the internal structure or the chemical composition of the extracted polymers. However, an examination of data for granules produced during the treatment of nominally similar wastes did suggest that there would be a relationship between polymer composition and granule strength in these cases.