Validation of the lead-in method in a practical shooting scenario.

The ability to determine bullet trajectories after a shooting incident can allow investigators to reconstruct the locations of individuals and the sequence of events that took place. By using trajectory rods, investigators can be provided with an immediate visual estimate as to what the path of the projectile may have been. In certain instances, the use of the probing method with trajectory rods is not appropriate due to their being a single, thin target material, or no secondary bullet impact site. In these cases, other methods such as the lead-in or the ellipse method may be useful. Overall, the lead-in method has not been well studied in the application to practical scenarios, such as those including bullet impacts on vehicle metal surfaces. This study has explored the accuracy of the lead-in method when a bullet impacts a typical vehicle metal surface using three firearm calibers, three blind participants, and two non-blind participants. The results of this study have shown that each caliber has its own characteristic error curve. In general, it was found that the lower the impact angle, the less errors were made by the participants. As the impact angle increases, the measurement errors increased, due to the smaller lead-in area present. The errors were found to have a wide range, with some being as low as 1° and some being as high as 13.9°. Further, it was found there was no significant effect on the errors of blind versus non-blind participants.
(© 2024 The Authors. Journal of Forensic Sciences published by Wiley Periodicals LLC on behalf of American Academy of Forensic Sciences.)