Composition, characteristics, and treatment technologies of condensable particulate matter present in flue gas emitted by coking plants in China.

To study the total particulate matter (TPM) in flue gas emitted by coking plants, a sampling system that could be used to collect filterable particulate matter (FPM) and condensable particulate matter (CPM) was designed and developed based on Method 202 recommended by the U.S. Environmental Protection Agency in 2017 and HJ 836-2017 issued by China. Using this system, FPM and CPM in flue gas emitted by four coking furnaces named A, B, C, and D were tested in China. Further, 9 water-soluble ions, 20 elements, and organic matter present in the CPM were simultaneously examined to determine their formation mechanisms. Statistical data suggested that the FPM emission level in the coking flue gas was low and the average mass concentration was less than 10 mg/m ³ . However, with high CPM and TPM emission levels, the TPM mass concentrations of A, B, C, and D were 130 ± 11.1, 84.4 ± 6.36, 35.1 ± 17.0, and 63.8 ± 13.0 mg/m ³ , respectively. The main component of TPM was CPM, and the average mass concentration of CPM accounted for 98%, 95%, 68%, and 95% of TPM in furnaces A, B, C, and D, respectively. Water-soluble ions were the important components of CPM, and the total concentration of water-soluble ions accounted for 70%, 87%, 42%, and 66% of CPM in furnaces A, B, C, and D, respectively. Toxic and harmful heavy metals, such as Mn, Cr, Ni, Cu, Zn, As, Cd, and Pb, were detected in CPM. The formation mechanism of CPM was analyzed in combination with flue-gas treatment. It was shown that the treatment process "activated carbon- flue-gas countercurrent-integrated purification technology + ammonia spraying" used in furnaces A and B was less effective in removing CPM, water-soluble ions, metals, and compounds than that of "selective catalytic reduction denitrification + limestone-gypsum wet desulfurization (spraying NaOH solution)" in furnaces C and D. Hence, different flue-gas treatment technologies and operation levels played vital roles in the formation, transformation, and removal of CPM from flue-gas. Organic components in CPM discharged from furnace A were determined via gas chromatography-mass spectrometry, and the top 15 organic components in CPM were obtained using the area normalization method. N-alkanes accounted for the highest proportion, followed by esters and phenols, and most of them were toxic and harmful to humans and ecosystems. Therefore, advanced CPM treatment technologies should be developed to reduce atmospheric PM _2.5 and its precursors to improve ambient air quality in China.
(© 2024. The Author(s).)