Wind-Induced Pressures on Solar Panels Mounted on Residential Homes.

This paper presents wind load investigations on solar panel modules mounted on low-rise buildings with gable roofs that have two distinct slopes. Wind loads on the solar panels mounted on several zones of the roofs were systematically investigated in a boundary-layer wind tunnel for different wind directions. The results from the wind-tunnel investigation are compared with ASCE provisions for residential bare roofs. The comparison shows a good agreement with the ASCE standard provisions for the main force resisting system. Nevertheless, the cladding loads on individual modules may be lower or higher than those on the corresponding area of a bare roof (depending on their location and array configuration and the roof's slope). Avoiding the roof critical zones (zones 3 and 2) is recommended to avoid high net minimum pressures acting on the solar panel modules. Solar panels mounted in zone 1 are locally subjected to higher suction at their outer edges. This is most likely attributed to the effect of a raised secondary roof formed over the main roof. The impact of the secondary roof effects is noticeable for small modules compared with larger modules. [ABSTRACT FROM AUTHOR]