TOTAL USE OF OLIVE TREE PRUNINGS BY MEANS OF HYDROTHERMAL AND COMBUSTION PROCESSES.

The aim of this work is to chemically characterize olive tree prunings and use the material in hydrothermal and combustion processes. The influence of the hydrothermal treatment conditions, with and without acid catalyst, of the main fraction of olive tree prunings (stems with a diameter > 1 cm) (temperature 150 to 190°C, time 0 to 20 minutes after reaching the operation temperature, liquid/solid ratio 6 to 8, and sulphuric acid concentration -0.1 to 0.5%), on the composition of resulting liquid fraction and on the solid yield of resulting solid fraction were studied. A polynomial model was found to reproduce the glucose and arabinose concentration, as well as the experimental results for solid yield with errors less than 20% at worst (< 10-12% in 90-95% of all cases). Good content values of glucose (5.33%) and arabinose (2.76%), and an acceptable value of the solid fraction yield (57.96%) were obtained operating with following values of temperature, time, liquid/solid ratio, and sulfuric acid concentration: 186°C, 18 min, 7:1, and 0.1%, respectively. With these values are saved, with respect to the use of higher values for operating variables, 2.1% energy, 80% sulfuric acid, and more than 10% of capital facilities. Residual fraction of olive tree prunings (leaves and stems with a diameter < 1 cm) had a heating value of 18699 kJ/kg, a flame temperature of 1207-2234 °C, and a dew point temperature of combustion gasses of 45-53 °C. [ABSTRACT FROM AUTHOR]