Rolling contact fatigue using solid thin film lubrication

Abstract: This paper addresses rolling contact fatigue (RCF) testing in ultra high vacuum (UHV) under high speed conditions. A ball–rod RCF test platform has been adapted for testing in UHV conditions that allows rapid accumulation of stress cycles, over 10 million cycles within 5h of testing at 130Hz rotation. The UHV environment and solid lubrication enables good vibration detection for the onset of spall. In this paper, approximately 0.2μm of silver is applied to the balls and provides sufficient lubrication for up to 25h of testing, or 50 million stress cycles in high vacuum at 130Hz. Seventy-nine RCF tests using thin-film silver lubrication have been completed covering two ball sizes, and two rod and ball materials. 9.53mm diameter Rex 20 steel and silicon-nitride (Si3N4) rods were tested against 7.94mm diameter Rex 20 and 12.7mm diameter M50 steel balls. It was found that ball size and material hardness did not affect the stress cycle life over a Hertzian contact stress range of 2.1–4.2GPa and Rockwell C hardness range of 62–77. Rather, the key limiter to test length is lubrication depletion based on 79 tests and an average silver thickness of 0.2μm. One of the two failure modes were observed for all tests: (i) early life spall of the silver coating, and (ii) depletion of silver lubrication followed by spall failure of both the ball and rod surfaces. A third-body storage model along with the Control Volume Fraction Coverage (CVFC) assumption and analysis was used to predict lubrication availability between asperities on the third body. There is good agreement between calculated and measured post-test lubrication thickness using the third-body storage model. [Copyright &y& Elsevier]