Heavily Ga-doped germanium layers produced by ion implantation and flash lamp annealing: Structure and electrical activation.

Heavily p-type doped Ge layers were fabricated by 100 keV Ga implantation and subsequent flash lamp annealing for 3 ms in the temperature range between 700 and 900 °C. For comparison, some samples were annealed in a rapid thermal processor for 60 s. Ga fluences of 2×1015, 6×1015, and 2×1016 cm-2 were chosen in order to achieve Ga peak concentrations ranging from values slightly below the equilibrium solid solubility limit of 4.9×1020 cm-3 up to 3.5×1021 cm-3 which corresponds to a maximum Ga content of about 8 at. %. The structure of the doped layer and the Ga distribution were investigated by Rutherford backscattering spectrometry in combination with ion channeling, cross-sectional electron microscopy, and secondary ion mass spectrometry. Temperature dependent Hall effect measurements were carried out in order to determine the electrical properties of the Ga-doped Ge layers. It is shown that by flash lamp annealing Ga diffusion into the bulk can be completely avoided and the Ga loss by outdiffusion from the surface is reduced. The lowest sheet resistance of 36 Ω/sq. was achieved for the medium Ga concentration annealed at 900 °C. The best Ga activation values are 73%, 60%, and 24% for the three Ga fluences under investigation. The Ga activation is correlated with the layer regrowth. Incomplete epitaxial regrowth as observed in some samples leads to lower activation. [ABSTRACT FROM AUTHOR]