Optimizing Cold Spray Parameters for High Entropy Alloy Coatings Using Taguchi and Box–Behnken Design Approaches for Mechanically Alloyed Powder.

The present study focused on optimizing the cold spray (CS) process parameters for depositing Fe20Cr20Mn20Ni20Co20 (Cantor alloy) coatings using mechanically alloyed (MA) powder. A two-step design of experiments approach was employed, beginning with the initial screening of input variables using the L8 Taguchi method, followed by the refinement of process parameters through the Box–Behnken design of experiments. Key performance indicators included deposition efficiency (DE), coating thickness per pass, and microstructural parameters including porosity, cracks, and interfacial defects/delamination. The study identified process gas temperature as the primary factor influencing both DE and thickness per pass. Higher gas temperature and pressure, combined with increased scanning speed, resulted in higher DE. The DE of the MA Cantor alloy powder peaked at around 14-15%, with a deposit density greater than 99% achieved at the highest process gas temperature and pressure (1000 °C and 60 bar, respectively). The average hardness of the optimal CS coating deposited using MA powder was found to be 679 ± 17 HV0.1, which is approximately 90% greater than the average hardness reported for CS coatings deposited using atomized powder. [ABSTRACT FROM AUTHOR]