Iron wool as a heating agent for magnetic catalysis: Experiments and analysis of heating properties under a high-frequency magnetic field.

Magnetically induced heterogeneous catalysis has been attracting attention due to its high energy efficiency and flexibility for dynamic reactor control. Iron wool is a commercial, low-cost, and versatile heating agent, which has been used in several magnetic catalysis studies, but its heating properties have never been investigated. Here, the properties of three types of Fe wool were studied using optical and electronic microscopy, x-ray diffraction, and measurements of both heating power and high-frequency hysteresis loops. The effects of strand width, packing, and magnetic field amplitude and frequency were studied. A maximum specific absorption rate (SAR) around 700 W/g under a rms field of 47.4 mT at 93 kHz was measured for the larger width Fe wool. High-frequency hysteresis loops were used to quantify the contribution of hysteresis losses and eddy currents to total heating. Eddy currents contribute 65%–90% to the global heating depending on the strand width. Coating the wool with SiO2 and Ni has negative effects on the SAR but none on hysteresis losses. It is interpreted as originating from the cut-off of inter-wire eddy currents due to the insulating (SiO2, oxidized Ni) nature of the coating. Last, it was found that adding more Fe wool in a given volume mostly decreases the SAR. This effect could be not only due to the absorption and/or screening of the field by surface strands but also due to magnetic interactions. The results described in this work give insights into the magnetic heating of microscale magnetic materials and optimize their use for heterogeneous catalysis. [ABSTRACT FROM AUTHOR]