Removal of Thiophenol from Water Using Sepiolite.

Crude oil and petroleum products contain various types of sulfur compounds: aliphatic and aromatic mercaptans, hydrogen sulfide, sulfides, disulfides, thiophene derivatives, etc. Some of these may dissolve in water only slightly, but their toxicity and corrosiveness indicate that even these small amounts should be eliminated from water. This work examines, for the first time, the removal of thiophenol (synonyms: benzenethiol, phenyl mercaptan) from water using sepiolite. This clay mineral (evaluated by SEM analysis) is an attractive natural sorbent characterized by its microporosity, which results from its crystalline structure and large specific surface area. Because the structure of thiophenol changes depending on the pH of the aqueous solution (due to the loss of a proton), the research was conducted at pH 4, 7 and 9. The detection of thiophenol in aqueous solution was investigated using UV spectroscopy. It was found that the adsorption of thiophenol is possible, but it occurs only in an acidic environment (pH 4). No sorption is observed at pH 7 or 9. The adsorption of thiophenol at pH 4 does not change significantly after changing the ionic strength of the aqueous solution (distilled water, 0.01 NaCl and 0.1 NaCl). The adsorption capacity of sepioliteis approximately 0.23–0.34 mg/g. Studies using infrared spectroscopy and fitting of Freundlich and Langmuir isotherm models to the results of adsorption experiments indicate that adsorption on unmodified sepiolite follows a physisorption mechanism. Additionally, to understand the behavior of thiophenol in the presence of sepiolite across different pH ranges, DFT/PCM/B3LYP/Aug-CC-pVDZ calculations were used to analyze the charge distribution on particular atoms in its structure. [ABSTRACT FROM AUTHOR]