Numerical simulation of wake flow around two square cylinders through passive control method.

Two-dimensional numerical simulations are performed to study the effect of height of control plates placed at the downstream location in a vertical direction of a channel for flow past two inline square cylinders. The numerical method used is the lattice Boltzmann method (LBM) and Reynolds number is kept constant at Re = 150 (Re = Uinf d/ν) for fixed gap spacing g = 3.5 (g = s/d). The height of the control plate varies from h = 0.1 to 8. First, the validity of code for the present problem and suitable grid points are checked along the selection of uniform inflow velocity. After that verification, the numerical simulations are performed to obtain the results under the effect of height of control plates using the passive control method. Calculated results are, in terms of vorticity contour, drag and lift coefficients, pressure contour, energy spectrum, and force statistics. Under the discussion of vorticity contour visualization, we obtained six types of flow mode and named them according to flow behavior and their characteristics. In pressure contour, it is visualized that the maximum pressure occurred at near the upstream position of the first cylinder as well as the upper and lower edge of the main cylinder as compared to the downstream cylinder and control plate, but at some position inside the domain, pressure contour contained negative values as well in between the gap of two square cylinders and control plate. In force statistics, we computed the values of Cdmean, Cdrms, Clrms, and St. Mean drag coefficients for both upstream cylinder (C1) and downstream cylinder (C2) are increased as the height of the control plate increased from 0.1 to 1.5, but as the height of the control plate reached its maximum value, the value of Cdmean turned toward the decline. The maximum value of Cdmean obtained at h = 2.25 and the minimum value occurred at h = 8. For cylinder C2, negative values for some selected heights such as h = 0.1–1.25 and h = 4–8 are also observed because of thrust. The value of the Strouhal number for both the cylinders C1 and C2 are similar at h = 0.1–4.5, but at h = 5, the values of the Strouhal number differ for both cylinders, but at the largest values of control plate's height, i.e., h = 6–8, the Strouhal number contains zero values for both cylinders C1 and C2. At these zero values of the Strouhal number, in vorticity contour jet type of flow mode is observed at h = 6–8, as a new flow mode, which is not identified before in the passive control method for flow past two or more square cylinders. [ABSTRACT FROM AUTHOR]