Effect of friction stir welding with different heat input on microstructure evolution, mechanical properties and deformation behavior of twin-induced plasticity steel.

The effect of friction stir welding (FSW) with different heat input on microstructure evolution, mechanical properties and deformation behavior of twin-induced plasticity steel was investigated in this paper. The results show that compared to the basal material (BM), the grain size in the stir zone (SZ) of FSW joint with low heat input was refined, and a large amount of deformation twins was formed. The grain was refined and numerous dislocations were formed in the stir zone-heat affected zone (SZ-HAZ) interface. In the FSW joint with high heat input, the grain size in SZ increased, while no deformation twins were observed. A large number of fine equiaxed grains were formed in the SZ-HAZ interface, while the grains in HAZ coarsened. Compared to the BM, the tensile strength and yield strength of low heat input joint increased to 1108 MPa and 597 MPa, respectively, while the elongation decreased to 50.4%, resulting in a strength-elongation product of 92% of BM. The joint with high heat input experienced a decrease in tensile strength, yield strength, and elongation to 806 MPa, 465 MPa, and 22.8%, respectively, with a strength-elongation product of only 30% of BM. During the tensile deformation process, the plastic deformation in the low heat input joint was mainly concentrated in BM, followed by HAZ, while SZ exhibited minimum plastic deformation, and the tensile fracture occurred at zone between SZ and HAZ. In the high heat input joint, the maximum plastic deformation occurred in the SZ, with lower plastic deformation in BM and HAZ, and finally fractured at the SZ. The constrain effect of different micro-zones and hindrance effect of dislocations and fine grains were main responsible for the deformation behavior of low and high heat input joints. • An ultra-high strength FSW joint was obtained, and its strength-elongation product reached 92% of the basal material. • The microstructure evolution and mechanical properties of different micro-zones of FSW joints were revealed. • The constrain and hindrance effects were mainly responsible for different deformation behavior of FSW joints of TWIP steel. [ABSTRACT FROM AUTHOR]