Progress and challenges in valorisation of biomass waste from ornamental trees pruning through pyrolysis processes. Prospects in the bioenergy sector.

Nowadays, the scarcity of energy resources is promoting the search for alternative energy sources, boosting interest in the use of forest lignocellulosic residue in the energy sector. In this study, the focus is on the energy recovery from two lignocellulosic residues originated during the pruning of ornamental trees (Horse Chestnut, CI, and False Acacia, FA). Both conventional and flash pyrolysis techniques were applied. The experimental pyrolysis variables were obtained from the study of the thermal behaviour of the pruning residues in thermogravimetric analysis. It was carried out under 5 heating rates and kinetic parameters were estimated using Flynn-Wall-Ozawa method. Results denoted higher maximum mass loss rate values for the same release temperature regions under FA experiments. Also, FA samples had lower final residues for the processes. However, activation energy values were so close for both species. FA was also linked to the faster reactions according frequency factor outcomes. Conventional pyrolysis of pruning residues was carried out in a horizontal oven of original design at a heating rate of 25 °C/min, at 750 °C and 60 min of permanence at that temperature; flash pyrolysis was tested in that oven at 750 and 850 °C. In these pyrolysis processes, three fractions were obtained: bio-char, bio-oil and gas. The physicochemical attributes of the bio-chars suggested their potential utility as biofuels (28.4–29.8 MJ/kg), adsorbent precursors or soil additives. Conventional pyrolysis bio-oils had a dominant monoaromatic hydrocarbons nature, with phenols being the most abundant (≥60%), while flash bio-oils contain mainly polycyclic aromatic hydrocarbons. Conventional pyrolysis gases contained up to 60 vol% of CO 2 ; flash pyrolysis gases had high combustible gas content (CO, CH 4 , H 2) and a low CO 2 content (<25 vol%). As a result, their calorific value (18.06 MJ/kg) exhibited a threefold increase compared to the gas produced through conventional pyrolysis (6.04 MJ/kg). [Display omitted] • Bio-chars can be used as fuels, as adsorbent precursor or as a soil additive. • In conventional bio-oils, phenols (≥60%) and the absence of PAHs stand out. • Flash bio-oils contain up to 95% PAHs (anthracene, phenanthrene, fluorene, etc). • Flash gases have high concentrations of CO, CH 4 and H 2 and low concentrations of CO 2. • Flash pyrolysis gases had higher HHV than conventional pyrolysis results. [ABSTRACT FROM AUTHOR]