Influence of solid solution treatment on fatigue crack propagation behavior in the thickness direction of 2519A aluminum alloy thick plates.

• Fatigue properties of 2519A Al alloy were obviously improved after DST. • Increased aspect ratio of grain and PFZ width after DST increased the resistance to crack expansion along GBs. • Bridging effect of second phase reduced after DST enhance alloy's fatigue properties. 2519A aluminum alloy thick plates have excellent applications in the military industry due to their superior ballistic resistance and fatigue properties. However, the delamination cracking along the thickness direction of this alloy hinders its further utilization. To address this issue and enhance the fatigue properties of this alloy, the effect of single-stage solid solution treatment (SST) and two-stage solid solution treatment (DST) on the fatigue crack propagation (FCP) behavior in the thickness direction of the alloy was investigated. Compared to the optimum SST, the volume fraction of the secondary phase of the alloy was reduced by 28.6% after DST. The precipitated phases were finer with more uniform distribution, and the volume fraction and number density of the precipitation increased by 47% and 30%, respectively. The DST resulted in a lower fatigue crack growth rate (FCGR) and an increase of 2.92% in the critical stress intensity factor value (Δ Kcr). The crack propagation mode of the alloy after SST was inter/transgranular crack propagation, while it was transgranular after DST. The aspect ratio of grain and the number of secondary phases in the alloy decrease after DST. Meanwhile, the grain boundary (GB) precipitation phase spacing, the precipitation-free zone (PFZ) width, and the spacing between the secondary phases increase. These changes result in decreased crack sources in the alloy and reduced the bridging effect of secondary phases on fatigue cracks, thus improving the fatigue performance of the alloy. [ABSTRACT FROM AUTHOR]