Rigid Mode Vibration Control for 250 HP Air Compressor System With Integrated Hybrid Air-Foil Magnetic Thrust Bearing (i-HFMTB).

This study aims to verify the effectiveness of the 250 HP class compressor system to which the integrated hybrid air-foil magnetic thrust bearing (i-HFMTB) proposed in (Ha et al., 2023, "Integrated Hybrid Air Foil-Magnetic Thrust Bearing (i-HFMTB) Part I: Preliminary Experimental Test for Rotordynamic Parameter Identification and Behavior With PD Control," ASME Paper No. GT2023-102860) [1] is applied, and the vibration and instability problems of air-foil journal bearing (AFJB) occurring in the rigid mode are controlled by i-HFMTB. The compressor rotor is supported by two AFJB (journal diameter = 60 mm) and an i-HFMTB, and the length and mass of the rotor are 550 mm and 15.24 kg, respectively. i-HFMTB has a structure in which air-foil thrust bearing (AFTB) pads are inserted into eight slotted active magnetic thrust bearings (AMTB), and PD control (proportional gain: 4000; differential gain: 10) is applied. The operating area was identified through AFJB's dynamic coefficients and rotordynamic analysis. As a result, in the experiment with the 250 HP compressor system supported only by two AFJB, sub- and super-synchronous vibrations were generated owing to the AFJB's insufficient load capacity and damping in the rigid mode (7000 rpm) region, and this instability did not disappear even upon increasing the speed to 15,000 rpm. However, when i-HFMTB was turned on in rigid mode, it was confirmed that the sub- and super-synchronous vibrations were significantly reduced. The thrust collar tilt angle was calculated through orbit trajectory analysis of the impeller and cooling side, and it was confirmed that the tilt angle of the thrust collar was reduced during i-HFMTB operation. [ABSTRACT FROM AUTHOR]