Comparative analysis of X‐band FSS fabricated by inkjet printing and conventional etching technique.

An investigation of a single‐layer band‐stop frequency selective surface (FSS) is designed and analyzed for X‐band application. The proposed FSS design primarily involves a cross‐shaped conductive patch with four square slots on each corner, and it is fabricated on the 3D‐printed polylactic acid (PLA) substrate. The design is resonating at 12 GHz with an insertion loss greater than 60 dB. The 10 dB bandwidth of the designed structure is 8.3% with respect to the resonant frequency. The results show that the design has polarization‐independent and angle‐insensitive transmission characteristics for incidence angles up to 60°. The simulation is carried out using CST Microwave Studio Suite, and the results are obtained. The physical mechanism of the designed structure is evaluated using the surface current distribution. The designed FSS is fabricated using two techniques, namely inkjet printing and conventional etching. Finally, the measurements of the fabricated structure are done using a vector network analyzer setup. [ABSTRACT FROM AUTHOR]