Mechanism of the synergistic effect of solid solution strengthening and fine grain strengthening in an as-cast Cu–9Ni–6Sn alloy induced by Mn.

The effects of Mn content on the Sn distributions, grain sizes, second phases, and mechanical properties of Cu–9Ni–6Sn- X Mn alloys (wt.%, X = 0, 0.1, 0.5, and 1.0) were studied in this paper. The mechanisms of acting and strengthening through which Mn could promote grain refinement in the alloy were discussed. The results showed that the addition of Mn transforms the as-cast microstructure of the alloy into equiaxed grains, and the grains are obviously refined. When the amount of Mn is approximately 0.1 wt%, the average grain size of this alloy is 91.75 μm, and the grain refinement effect is greatest in the experimental range. In addition, Mn increases the uniformity of the distribution of Sn in the as-cast microstructure. Differential scanning calorimetry (DSC) analysis revealed that the addition of Mn increases the undercooling of the as-cast Cu–9Ni–6Sn alloy and decreases in the critical nucleation radii of the grains. Further microstructure observation showed that Mn is dissolved mainly in the γ-(Cu,Ni) 3 Sn phase. Consequently, the interfacial relationship between the γ-(Cu,Ni) 3 Sn phase and the matrix transforms from incoherent to semicoherent. Compared with those of the Cu–9Ni–6Sn alloy, the strength and elongation of the alloy with added Mn are relatively great. When the content of Mn is 0.1 wt%, the strength of the alloy increases from 359.75 MPa to 423.54 MPa, while the elongation remains at 19.14 %. The synergistic effect of solution strengthening and fine grain strengthening of Mn is the main reason for the great improvement in the mechanical properties of the alloy. [ABSTRACT FROM AUTHOR]