Vacuum laser beam welding of AZ31 magnesium alloy: Weld formability, microstructure and mechanical properties.

• Subatmospheric environment was used in AZ31 Mg alloy laser welding. • The effect of ambient pressure on the keyhole and weld pool behaviour in laser welding of AZ31 Mg alloy were investigated. • Vacuum laser welding was used to join 10 mm-thick AZ31 Mg alloy plates in a bottom-locking configuration. • Defect-free deep penetration magnesium weld was achieved by vacuum laser welding. Laser welding of magnesium alloy is still challenging because of the frequently occurred defects. In this work, a promising vacuum laser welding technique was used to join AZ31 magnesium alloy. The effect of ambient pressure on weld surface appearances and weld fusion cross sections was symmetrically investigated. It was found that the penetration depth increased and the weld width became narrower with the descending of ambient pressure from 101 kPa to 10 kPa. However, the penetration depth did not increase and even decreased when the ambient pressure further decreased to 1 kPa and 0.1 kPa. In addition, hump defects occurred at lower ambient pressure of 1 kPa and 0.1 kPa. The weld pool and keyhole behaviors were in-site observed using a high-speed camera at various ambient pressures. The results showed that unstable keyhole and turbulent flow were found in the molten pool at 101 kPa. The keyhole became more stable as the ambient pressure decreased from 101 kPa to 10 kPa. When the ambient pressure further decreased to 1 kPa and 0.1 kPa, the liquid metal thickness between keyhole wall and weld pool periphery became very narrow, which sometimes resulted in unstable absorption of the laser energy. Finally, a 10 mm-thick bottom-locking weld was made under vacuum. The average grain diameter of the weld in vacuum is 28.4 μm, which is much lower than 46 μm in atmosphere. The tensile results showed that the average ultimate tensile strength and the elongation of the joints welded in vacuum at 10 kPa was 8.8 % and 44.0 % higher than that of the joints welded in atmosphere respectively. The enhanced mechanical properties were attributed to the reduced porosity and refined microstrustures of the weld joint made under vacuum. [ABSTRACT FROM AUTHOR]