High-consistent optical fiber photoacoustic generator with carbon nanoparticles-PDMS composite.

• Fabrication of high consistent spin-coated optical fiber photoacoustic generator. • High consistent and high-frequency broadband miniature photoacoustic generator. • Potential in high-resolution ultrasound imaging with high signal to noise ratio. Optical fiber photoacoustic (PA) probe is considered to have great prospects in high resolution invasive imaging due to the advantages of flexible, miniaturized broadband ultrasonic excitation. Unfortunately, more attentions are currently focused on the fabrication of the PA probe with a high PA conversion efficiency, instead of the consistency of the developed probe that is of great importance for practical applications. In this paper, in consideration of the coating thickness and flatness closely concerned with the consistency, a number of PA probes with 15 wt.% carbon nanoparticles (CNPs) and polydimethylsiloxane (PDMS) composite were fabricated by a spin-transfer method with the help of transferring uniformly spin-coated film on the endface of an optical fiber. Underwater ultrasonic detection showed that the fabricated probes exhibited a good consistency with the corresponding lower coefficients of variation of 1.7%, 1.4% and 1.1% for the sound pressure, center frequency and bandwidth, sharply reduced by 89%, 72% and 81% in comparison with the commonly used dip-coating probes tested in this work. Also, due to the thinner film obtained through the presented fabrication method, the maximum PA pressure value of 1.04 MPa with a -6 dB bandwidth of 54.2 MHz was achieved, which further demonstrates a great potential in high-resolution ultrasound imaging utilizing multiple probes with high consistency. [ABSTRACT FROM AUTHOR]