Optimization of a continuous flow electrocoagulation as pretreatment for membrane distillation of the waste stream in vinyl ester resin production.

[Display omitted] • Optimization of VERW pretreatment via EC and PEC was investigated. • Organics in VERW was effectively removed via EC followed by PEC. • Membrane fouling of DCMD was significantly alleviated by PEC. • The volume of VERW was remarkably reduced and the high-quality distillate was obtained. Vinyl ester resin production wastewater (VERW) contains high concentrations of organics particularly, methacrylic acid and bisphenol A, which are hazardous chemicals and harmful to the aquatic environment. Therefore, there is an urgent need to properly treat the effluent before discharge into the aquatic system. In this work, direct contact membrane distillation (DCMD) was explored as an advanced treatment of the VERW pre-treated by a continuous flow electrocoagulation (EC) and peroxi-electrocoagulation (PEC) processes. Optimization of EC and PEC processes were investigated and the DCMD performance was evaluated. Results showed that the optimal value of current density and polyacrylamide (PAM) dosage was 15 mA/cm2 and 1 mg/L, respectively in the EC process. For the PEC process, the optimal addition of hydrogen peroxide (H 2 O 2) dosage was four times of the chemical oxygen demand (COD) concentration of EC effluent. The COD of VERW was effectively removed via EC followed by PEC (EC-PEC), resulting in the significant alleviation of membrane fouling during DCMD filtration of VERW. The initial flux of DCMD filtration of VERW pre-treated via EC-PEC improved by 35%, compared that only pre-treated by EC. Moreover, the concentration factor (CF) of the DCMD system reached up to 8.1 and the conductivity of distillate was less than 33.2 μS/cm. Hence, the EC and membrane distillation hybrid process paves a new way for the effective treatment of waste steam from resin production. [ABSTRACT FROM AUTHOR]