Research on the effect of thermal treatment on the crack resistance curve of marble using notched semi-circular bend specimen.

• Crack resistance curves of heat-treated marble were tested using notched semi-circular bend specimens. • Digital image correlation method was used to analyze the crack propagation of marble specimens. • Thermal effects on the crack resistance curves and fracture process zone of marble were analyzed and discussed. The crack resistance curve is widely used to describe the complete fracture process of quasi-brittle materials. In the paper, the crack resistance curves of thermally treated marble were tested through the notched semi-circular bend specimens. The acoustic emission (AE) and digital image correlation (DIC) techniques were used to monitor the fracture behaviors of the specimens during the test. The AE results indicated that the crack will initiate from the notch when the axial load is less than the peak load. And, when the axial load reaches the peak load, the DIC results demonstrated that there exists a large fracture process zone (FPZ) in front of the crack notch. The effect crack length was calculated by the compliance method, which is coincided with the DIC results. The amplitude of the crack resistance curves decreases with the increase of treatment temperature, which suggested that the fracture resistance of the specimen declines due to thermal treatment. Based on the K-resistance curves, the initial fracture toughness, unstable fracture toughness, and fracture toughness when FPZ is fully formed have been determined for the thermally treated specimens. The results showed that these parameters both decrease in the increase of treatment temperature. Moreover, The FPZ length first increases and then decreases with the increase of normalized crack length and the critical and maximum non-dimensional FPZ length tends to increase with the increase in treatment temperature. [ABSTRACT FROM AUTHOR]