Determination of a pre-heating sequence for the DONES Target Assembly.

• The pre-heating of the DONES Target Assembly mock-up has been investigated using the Abaqus FEM code. • A campaign of steady-state analyses has been carried out to select an optimal configuration for the electrical heaters. • Results obtained from detailed transient analysis partially confirmed results obtained from steady-state calculation. • The selected configuration will be adopted for the execution of the experimental campaign. Within the activities promoted by the EUROfusion consortium in support of the design and construction of the DEMO Oriented NEutron Source (DONES), a mock-up of its Target Assembly (TA), based on the configuration with a "bayonet" Back-Plate (BP) and available at ENEA Brasimone labs, is being adopted for the execution of experimental activities aiming at the validation of specific aspects of the target design. Despite the "integral"-TA concept is the current reference, experimental tests concerning the TA pre-heating phase are not significantly affected by the TA concept and are still representative even though conducted on the bayonet-TA concept. Indeed, the main objective of the pre-heating phase is to raise the TA temperature up to a value close to that of the lithium flow in nominal condition (250 °C). In particular, one of the main concerns is to keep the BP at a temperature higher than 200 °C to avoid possible local lithium freezing. In order to support the afore-mentioned tests, a numerical research campaign has been launched by ENEA Brasimone in collaboration with the University of Palermo with the goal of determining an optimal design of the electrical heaters, both in terms of temperature set-points and geometrical layout. To this purpose, several configurations have been assessed following a theoretical-computational approach based on the Finite Element Method (FEM) and adopting the Abaqus FEM code. In a first phase, different electric heater layouts were assessed by means of steady state thermal analyses. Once the most promising scenario was selected, a detailed thermal transient analysis was carried out. An iterative procedure, based on the analysis of the maximum temperature achieved within the mock-up most critical components, was followed in order to determine the duty cycle of the electric heaters. The obtained numerical results are herewith reported and critically discussed. [ABSTRACT FROM AUTHOR]