齿盘式棉秆收获机的设计.

Cotton stalk is an important renewable resource. China is rich in cotton stalk, if such a large amount of resources are recycled, it will produce huge economic benefits. But most of them are not recycled at present. In order to improve the mechanized recovery level of cotton stalk, study the influence of different parameters on the mechanized recovery of cotton stalk, and solve the outstanding problems such as high cotton stalk plucking rate and high cotton stalk leakage rate, this paper studied and designed a toothed disc cotton stalk harvester. The machine was consisted of suspension device, limit wheel, pull-out tooth plate, stalk discharge device, hydraulic motor, hydraulic pipeline and hydraulic control box. The key component of the machine was a toothed disc type stalk pulling device. During operation, the cotton stalk was lifted out through the toothed disc, and then the cotton stalk was discharged to the surface through the stalk discharge device. Leakage rate and plucking rate of cotton stalk were the main parameters to evaluate the performance of toothed disc cotton stalk harvester. In this paper, Box-benhnken central combination test method was used to study the working parameters of toothed disc cotton stalk harvester. Three-factor and three-level quadratic regression orthogonal test was designed. The three-dimensional model of response surface was established with the diameter of the toothed disc, the toothed disc speed ratio and the lifting height as the influencing factors. The influence of each factor on the quality of work was analyzed, and the influencing factors were optimized synthetically. The results showed that the lifting height and the toothed disc speed ratio had significant effects on the cotton stalk plucking rate (P< 0.01), while the lifting height, the diameter of the toothed disc and the toothed disc speed ratio had significant effects on the rate of cotton stalk leakage rate (P<0.01). The working parameters of the machine were deduced from the regression model optimization as follows: the lifting height was 66.2 mm, the diameter of the toothed disc was 627.59 mm, and the toothed disc speed ratio was 0.57. In November 2018, field test was carried out in the Yellow River Delta (Binzhou) National Agricultural Science and Technology Park. Test area was divided into 17 test plots (each plots is 30 m×0.76 m), leakage rate and plucking rate of cotton stalk at each test plot were calculated. The results of the Daejeon experiment showed that when the lifting height was 70 mm, diameter of the toothed disc was 630 mm and the toothed disc speed ratio was 0.57, the cotton stalk plucking rate could reach 1.5% and the cotton stalk leakage rate was low to 3.0%. The test results showed that the theoretical results were coincident with the measuring results, and the error between them was less than 4%. The research results can provide references for the structure improvement design and operation parameters optimization of toothed disc cotton stalk harvester. [ABSTRACT FROM AUTHOR]