Experimental evaluation of surface quality characteristics in laser machining of nickel-based superalloy.

This paper reports the investigation results of CO 2 laser machining of Inconel 718 superalloy. Investigation on the effects of the two important laser parameters power and travel speed on machinability i.e. material removal rate, kerf wall inclination, and average surface roughness of Inconel 718 has been conducted. Increased kerf wall inclination has been found with slow travel speed and increasing power. Low power and high travel speed produced maximum material removal rate and minimum surface roughness. Premature state of fusion has advanced dross regime at a slow cutting speed of 3.3 m/min and leading to a surface roughness of 9.3 microns maximum. Dendrite structures were formed and changes in surface hardness were observed due to high travel speed. Therefore, based on the investigation, slow travel speed with appropriate laser power is recommended for the improved machinability and surface quality during laser machining of Inconel 718 superalloy. [ABSTRACT FROM AUTHOR]