Calculation of proppant-carrying flow in supercritical carbon dioxide fracturing fluid.

As a new clear and efficient fracturing fluid, supercritical carbon dioxide (SC-CO 2 ) has many advantages in the development of unconventional oil and gas resources, such as no harm to the reservoir, improving the reservoir permeability and fluid flow resistance, quickly completely flowing back after fracturing. Based on the principle of suspension energy balance, an equilibrium flow rate model of proppant-carrying flow of SC-CO 2 is derived, and calculation errors are 3.32% and 4.54%, respectively, compared with equilibrium flow rates obtained from experiments under different density and particle sizes. By considering the change of fluid internal energy and flow work, filtration characteristics, physical parameters, and SC-CO 2 –rock adsorption in the SC-CO 2 fracturing process, a proppant-carrying flow calculation model of the SC-CO 2 fracturing fluid is established based on temperature–pressure field coupling, fracture and filtration zone coupling, and SC-CO 2 fluid and proppant coupling. In the experiment, the heights of nine groups of proppant embankments were measured, and the average model prediction error value is 3.43%. SC-CO 2 has a similar proppant-carrying capacity to that of clear water under the high Reynolds number condition. Based on the proppant-embankment prediction model of SC-CO 2 fracturing, through analyzing proppant-carrying characteristics of the SC-CO 2 fracturing fluid, the proppant concentration distribution and proppant embankment section are obtained at different fracturing times. According to the calculation, as the fracturing fluid pumping rate increases, proppant density and proppant particle size will decrease, the viscosity of the SC-CO 2 fracturing fluid system will increase, and proppant accumulation height can be reduced over a small range, while proppant accumulation length will experience a greater increase along the fracture length direction. During field operation of SC-CO 2 fracturing, the proppant pumping process should be optimized according to the proppant embankment section and proppant concentration should be choose increased in small steps to meet fracture propping requirements. [ABSTRACT FROM AUTHOR]