Evaluation of the phase ratio for three C18 high performance liquid chromatographic columns.

For a chromatographic column, phase ratio Φ is defined as the ratio between the volume of the stationary phase V st and the void volume of the column V 0 , and it is an important parameter characterizing the HPLC process. Although apparently simple, the evaluation of Φ presents difficulties because there is no sharp boundary between the mobile phase and the stationary phase. In addition, the boundary depends not only on the nature of the stationary phase, but also on the composition of the mobile phase. In spite of its importance, phase ratio is seldom reported for commercially available HPLC columns and the data typically provided by the vendors about the columns do not provide key information that would allow the calculation of Φ based on V st and V 0 values. A different procedure for the evaluation of Φ is based on the following formula: log k′ j = a log K ow,j + log Φ , where k ′ j is the retention factor for a compound j that must be a hydrocarbon, K ow ,j is the octanol/water partition coefficient, and a is a proportionality constant. Present study describes the experimental evaluation of Φ based on the measurement of k ′ j for the compounds in the homologous series between benzene and butylbenzene for three C18 columns: Gemini C18, Luna C18 both with 5 μm particles, and a Chromolith Performance RP-18. The evaluation was performed for two mobile phase systems at different proportions of methanol/water and acetonitrile/water. The octanol/water partition coefficients were obtained from the literature. The results obtained in the study provide further support for the new procedure for the evaluation of phase ratio. [ABSTRACT FROM AUTHOR]