Search

The paper proposes a novel methodology to locate and quantify entrapped air pockets created during pipe-filling events often found in intermittent water supply systems. Different filling conditions were tested in an experimental pipe with a high point. Measurements were taken and video recordings were carried out to assess air pocket volumes for different air release conditions at the downstream end of the pipe. The stochastic nature of air pocket creation resulted in varying air volumes. A new numerical model capable of simulating the air pocket creation, dragging and entrainment has been proposed. The new model, AirSWMM, was implemented as an extension of the Stormwater Management Model (SWMM) with stochasticity of air pocket formation reproduced by simulations with different air entrainment rates. The obtained numerical results show that the proposed model, even though based on a single-phase one-dimensional flow, can accurately locate and approximately quantify the entrapped air pocket volumes., Sanitary Engineering

The management of an Urban Drainage System (UDS) is a complex task, as it requires extensive knowledge about precipitation regime, hydrological features of the catchment, hydraulic characteristics of the drainage network, and information about the water use by the served inhabitants. Complex semi-distributed hydrological and physically based hydraulic models are nowadays available to summarise such information and run simulations. However, in many cases, the uncertainty of the available hydrological information hampers the use of complex models. Hence, simple models with few parameters and small computational effort may be preferable, especially for UDS management problems requiring the execution of many simulations. This paper proposes a convenient approach to define effective lumped Simplified Models (SMs) of UDSs, the parameters of which can be estimated directly from cartographic information. For several case studies of UDS with different morphological and topological characteristics, SMs were built, capable of reproducing the hydrographs provided by available semi-distributed Detailed Models (DMs), assumed as benchmark in absence of measured hydrographs. To this aim, the SWMM simulation software was used, and the SM lumped parameters were calibrated by maximising the goodness of fit between the hydrograph of the DM and of the SM. The results show that SMs satisfactorily predict the hydrographs for all the case studies, and that robust relationships between the calibrated parameters and morphological and topological characteristics of the UDS can be established. This suggests that SMs can be used by decision makers for preliminary design, planning studies and management problems of UDSs, as their parameters can be soundly estimated from cartographic information. An example of application of SMs to Combined Sewer Overflow prediction is also presented., Green Open Access added to TU Delft Institutional Repository ‘You share, we take care!’ – Taverne project https://www.openaccess.nl/en/you-share-we-take-care Otherwise as indicated in the copyright section: the publisher is the copyright holder of this work and the author uses the Dutch legislation to make this work public., Sanitary Engineering

Urban areas are constantly developing and thereby affect the local water cycle. Real-time control (RTC) strategies are used to operate urban drainage systems optimally during these transitions. This paper aims to develop a methodology to study the impacts of common gradual changes occurring in the urban environment (densification of the urban area and implementation of blue-green infrastructure), forming cumulative transitions, on the functioning of real-time optimization procedures. A new generic methodology, relying on a comprehensive evaluation strategy based on three indicators assessing the continued optimal performance of RTC was proposed. This methodology was applied to two urban drainage catchments in Eindhoven and Rotterdam using both probabilistic and projected transitional paths. Based on the results obtained it can be noted that the performances of the RTC procedures were not strongly affected by the modeled transitions although the relative performance compared to the maximum performance potential decreases significantly with the large-scale implementation of blue-green infrastructure, indicating that the revision of RTC procedures could improve the sewer system functioning further. The relative performance loss associated with the modeled transitions was higher for model predictive control compared to heuristic RTC procedures for one case study and vice versa for the other. Continuous re-evaluation of the RTC strategy is, therefore, an important but overlooked part of the implementation of RTC procedures., Sanitary Engineering

Model Predictive Control (MPC) of Urban Drainage Systems (UDS) has been established as a cost-effective method to reduce pollution. However, the operation of large UDS (containing over 20 actuators) can only be optimized by oversimplifying the UDS dynamics, potentially leading to a decrease in performance and reduction in users' trust, thus inhibiting widespread implementation of MPC procedures. A Heuristic And Predictive Policy (HAPPy) was set up, relying on the dynamic selection of the actuators with the highest impact on the UDS functioning and optimizing those in real-time. The remaining actuators follow a pre-set heuristic procedure. The HAPPy procedure was applied to two separate UDS in Rotterdam with the control objective being the minimization of overflow volume in each of the two cases. Results obtained show that the level of impact of the actuators on the UDS functioning changes during an event and can be predicted using a Random Forest algorithm. These predictions can be used to provide near-global optimal actuator settings resulting in the performance of the HAPPy procedure that is comparable to a full-MPC control and outperforming heuristic control procedures. The number of actuators selected to obtain near-global optimal settings depends on the UDS and rainfall characteristics showing an asymptotic real-time control (RTC) performance as the number of actuators increases. The HAPPy procedure showed different RTC dynamics for medium and large rainfall events, with the former showing a higher level of controllability than the latter. For medium events, a relatively small number of actuators suffices to achieve the potential performance improvement., Sanitary Engineering

REAL-time control (RTC) is a technique used to dynamically control urban drainage systems to utilise the existing infrastructuremore optimally. It can be used to achieve a number of objectives aiming to improve the functioning of the urban drainage system, typically through the reduction of pollution. When heavy rainfall occurs, combined sewer systems (CSSs) can cause combined sewer overflows (CSOs) to discharge diluted, yet untreated, wastewater into receiving water bodies. These discharges can lead to ecological damage and pose a public health hazard, resulting in more stringent legislation necessitating the reduction of CSO discharges. To achieve this, expensive upgrades to the urban drainage system (UDS) have traditionally been used. RTC can reduce or negate the need for these expensive upgrades by fully utilising the existing infrastructure. RTC increasingly relies on more complex algorithms and data streams due to the rise of cheaper computing power and sensors, leading to a better understanding of the systems and more potential for dynamic optimisation. Uncertainties (inherent to modelling and monitoring exercises) can affect the functioning of these RTC procedures, but the influence of uncertainty on the performance of RTC procedures is poorly understood. This is an often quoted reason against the implementation of RTC strategies as a whole. The aim of this thesis is therefore to increase the understanding of how uncertainties can affect the performance of RTC procedures. Using three case studies (urban drainage systems of WWTP Eindhoven, Hoogvliet and Dokhaven) and both heuristic and real-time optimisation procedures, this aimwas assessed., Sanitary Engineering

Urban Drainage Systems can cause ecological and public health issues by releasing untreated contaminated water into the environment. Real-time control (RTC), augmented with rainfall nowcast, can effectively reduce these pollution loads. This research aims to identify key dynamics in the nowcast accuracies and relate those to the performance of nowcast-informed rule-based (RB)-RTC procedures. The developed procedures are tested in the case study of Rotterdam, the Netherlands. Using perfect nowcast data, all developed procedures showed a reduction in combined sewer overflow volumes of up to 14.6%. Considering real nowcast data, it showed a strong ability to predict if no more rain was expected, whilst performing poorly in quantifying rainfall depths. No relation was found in the nowcast accuracy and the consistency of the predicted rainfall using a moving horizon. Using the real nowcast data, all procedures, with the exception of the one predicting the end of the rainfall event, showed a significant risk of operative deterioration (performing worse than the baseline RB-RTC), linked to the relative performance of the nowcast algorithm. Understanding the strengths of a nowcast algorithm can ensure the reliability of the RB-RTC procedure and can negate the need for detailed modelling studies by inferring risks from nowcast data., Sanitary Engineering

Model Predictive Control (MPC) of combined sewer systems can reduce environmental degradation caused by uncontrolled overflows. However, practical uncertainties are often neglected when assessing the potential of MPC strategies. This paper aims to understand the risks associated with using a non-perfect internal MPC-model, real precipitation forecast, and realistic dynamic system capacity fluctuations. An MPC with the objective to reduce the total combined sewer overflow (CSO) volume was implemented in the case study of Eindhoven in the Netherlands where highly sensitive waterways receive the sewer overflows. Two types of risks were identified: relative system performance loss and operative deterioration. The former entails a practical decrease in efficacy of controlling CSO spills compared to the theoretical situation, whereas the latter describes the aggravation of environmental pollution compared to a static form of system operation. The results obtained demonstrate that precipitation forecast uncertainty is associated with a small relative system performance loss. Opposite to this, significant performance loss was observed as a consequence of uncertainties in the internal MPC model and the actual sewer system capacity available. The latter caused additional combined sewer overflows compared to a statically optimised control for smaller precipitation events., Sanitary Engineering

Real Time Control (RTC) is widely accepted as a cost-effective way to operate urban drainage systems (UDS) effectively. However, what factors influence RTC efficacy and how this might change in the long term remains largely unknown. This paper reviews the literature to understand what these factors likely are, and how they can be assessed in the future. Despite decades of research, inconsistent definitions of the performance of RTC are used, hindering an objective and quantitative examination of the benefits and drawbacks of different control strategies with regard to their performance and robustness. Furthermore, a discussion on the changes occurring and projected to occur to UDS reveals that the potential impact of these changes on the functioning of RTC systems can be significant and should be considered in the design stage of the RTC strategy. Understanding this 'best-before' characteristic of an RTC strategy is the key step to ensure long term optimal functioning of the UDS. Additionally, unexplored potential for RTC systems might exist in the transitions, rehabilitation and construction of drainage systems. The research gaps highlighted here could guide the way for further development of RTC strategies, and enabling more optimal, long term implementation of RTC for urban drainage systems., Sanitary Engineering

Data collection in urban drainage systems comes with many challenges. However, many examples already exist, containing numerous useful lessons learned. This chapter therefore contains several urban drainage and stormwater management metrology case studies, selected to cover a wide range of scopes, scales, objectives, climates, data validation methods, and data storage approaches. The case studies are initiated by academics as well as by institutions from the water industry., Sanitary Engineering

To evaluate the performance of Real Time Control (RTC) of urban drainage systems (UDS) a comparison is made with the pre-RTC situation, making the RTC performance dependent on the functioning of the UDS prior to implementation. To standardise things, a generalised baseline is formulated here as the operation with optimal static settings of the UDS. Two maximum theoretical potential performances are then calculated, one including and one excluding system limitations. These are combined with the generalised baseline to form Realised Potential Indicators (RPIs), objective values which indicate the proximity of the RTC strategy to its maximum potential. The proposed methodology was demonstrated on the case study of Eindhoven, the Netherlands. The results obtained show that using RPIs allows for a more objective assessment and improved understanding of the efficacy of different RTC procedures. Additionally, the RPIs can provide an indication if RTC is sufficient to achieve the desired UDS performance., Sanitary Engineering