Search

For acquisition of accurate aerodynamic parameters of the pipeline suspension bridge, the numerical wind tunnel model for the typical girder section of the oil and gas pipeline suspension bridge was built, and SST k-ε model was used as the numerical wind tunnel turbulence model. The bypass flow pressure field distribution acquired from the numerical wind tunnel shows that the negative pressure area on the upper and lower surfaces of the pipeline is obvious, the largest positive pressure area appears on the windward side of the pipeline, and the pressure difference between the windward side and the leeward side of the truss girder in the inflow direction is particularly obvious. The bypass flow velocity field distribution shows that the pipeline and truss girder exert significant blocking effect on the wind speed, and the flow separation and vortex shedding phenomena occur apparently on the pipeline, windward railings and truss girder. According to the root mean square pressure of the flow field, vortex vibration is most likely to occur in the inflow side truss. Through the analysis of the three component coefficients of different pipeline diameters and different girder widths at the wind attack angles of －3°, 0° and 3°, it is concluded that the girder width has little influence on resistance coefficient and lift coefficient, and the torsion coefficient decreases with the increase of the girder width at －3° wind attack angle. The pipeline diameter definitively influences the three component coefficients, that is, with the increase of pipeline diameter, the resistance coefficient increases gradually, while the lift coefficient and torsion coefficient decrease gradually. The research results are expected to provide wind-resistant data support for the design of suspension bridge deck structure and the piping layout.