Search

The objective of this study was to examine the performance of cutoff walls in controlling saltwater intrusion in stratified heterogeneous coastal aquifers. Numerical and laboratory experiments were completed in laboratory-scale aquifer where the effectiveness of cutoff walls was assessed in three different configurations, including a homogeneous scenario, a stratified aquifer with high K–low K–high K pattern (case HLH) and another stratified aquifer with low K–high K–low K pattern (case LHL). The results show that the cutoff wall was effective in reducing the saltwater wedge in all the investigated cases of layered-aquifers with toe length reduction of up to 43%. The wall exhibited more wedge reduction in shallower than steeper hydraulic gradients. However, the soil stratification appeared to lessen the overall performance of the wall compared to the homogeneous case. The aquifer stratification disrupted the flow dynamics, and thus affected the freshwater velocity at the wall opening to various degrees, depending on the layering pattern. The presence of an interlayer of low k (case HLH) inhibited the downward movement of the freshwater towards the wall opening, and thus decreasing the repulsion ability of the wall. Moreover, the presence of an underlying low permeability layer (case LHL) was found to obstruct the freshwater flow in the lower part of the aquifer, thereby slowing down the velocity through the wall opening. Numerical analysis of other layering patterns of monotonically increasing/decreasing permeability from top to bottom showed that the cutoff wall remained effective in repulsing the seawater wedge. [ABSTRACT FROM AUTHOR]

This paper provides a thorough investigation of the effect of a top low-permeability (TLK) layer on transient saltwater intrusion dynamics prompted by water table fluctuations and sea level rise. Laboratory experiments were conducted on a 2D-sandbox and numerical simulations were performed using the SEAWAT code. Four cases were investigated, including a homogeneous case and three cases, where the top layer thickness (W top) was equal to 0.2H, 0.33H and 0.5H, respectively, where H was the aquifer thickness. The experimental and numerical results show that the toe length decreases linearly with increasing the thickness of the TLK layer. The results also suggest that lowering the permeability of the upper part of the aquifer causes faster saltwater removal process. The sensitivity analysis shows that decreasing the top layer permeability causes further reduction of the intrusion length. Nonetheless, the results evidence that this method yields relatively little reduction of the saline water intrusion length if the upper layer thickness is inferior or equal to a fifth of the total aquifer thickness, regardless of the permeability value of the top layer. The field-scale modelling results demonstrate that the performance of the TLK layer weakens noticeably as the hydraulic gradient decreases. The results show that the TLK layer achieved a maximum saltwater wedge reduction of 31% in the case where W top = 0.75H, which means that lowering the permeability of three fourths of the aquifer thickness only induced a toe length reduction by nearly a third of its original length. In addition to providing a quantitative analysis of SWI dynamics in bi-layered coastal aquifers, this study questions the performance and practicality of the artificial reduction of the upper aquifer permeability as a countermeasure for seawater intrusion control. • The impact of a top low-K layer on seawater intrusion was quantitively analysed. • The reduction in the intrusion length was linearly correlated with top layer thickness. • The low-K top layer only had noticeable reduction of SWI when its thickness is 50% the aquifer thickness or greater. • The low-K layer achieved a maximum saltwater wedge reduction of 31%. [ABSTRACT FROM AUTHOR]