Search

Wire rope will have defects such as local faults (LF) and loss of metal area (LMA) during the long-term using process. The nondestructive testing method of magnetic flux leakage (MFL) has been widely used in wire rope defect detection. Currently, the detecting distance between magnetic sensors and wire rope with the MFL method is relatively small (2–5 mm). Considering the inner surface of the sensor head is close to the wire rope, it quickly leads to the sensor head scraping off the surface oil of the wire rope or being stuck by a cut wire in the course of MFL detection. Therefore, it is challenging to realize the sensor with MFL detection of wire rope obtaining the weak signal at a large lift-off (>30 mm). This study used finite element analysis to verify if the MFL signal exists at the large lift-off (>30 mm). Meanwhile, the sensor head was improved using an open magnetizer to make the wire rope reach saturation and excite enough magnetic leakage field. By combining magnetic sensing and coupling and a weak analog signal processing method, not only was the signal effectively detected, but also the signal-to-noise ratio (SNR) was improved. Finally, experiments verify the feasibility of detecting defects at a large distance. The method also has been applied in the high-speed detection of wire rope, which can detect broken wire of 1 mm diameter. [ABSTRACT FROM AUTHOR]

Wire rope will have defects such as local faults (LF) and loss of metal area (LMA) during the long-term using process. The nondestructive testing method of magnetic flux leakage (MFL) has been widely used in wire rope defect detection. Currently, the detecting distance between magnetic sensors and wire rope with the MFL method is relatively small (2–5 mm). Considering the inner surface of the sensor head is close to the wire rope, it quickly leads to the sensor head scraping off the surface oil of the wire rope or being stuck by a cut wire in the course of MFL detection. Therefore, it is challenging to realize the sensor with MFL detection of wire rope obtaining the weak signal at a large lift-off (>30 mm). This study used finite element analysis to verify if the MFL signal exists at the large lift-off (>30 mm). Meanwhile, the sensor head was improved using an open magnetizer to make the wire rope reach saturation and excite enough magnetic leakage field. By combining magnetic sensing and coupling and a weak analog signal processing method, not only was the signal effectively detected, but also the signal-to-noise ratio (SNR) was improved. Finally, experiments verify the feasibility of detecting defects at a large distance. The method also has been applied in the high-speed detection of wire rope, which can detect broken wire of 1 mm diameter.

In the conventional eddy current testing (ECT), it is difficult to estimate wall thinning from outside of pipes without removing the covered materials due to the large lift-off between a pipe surface and a sensor. In order to overcome this difficulty, a long-pulsed excitation system has been developed with a magnetic sensor, by which the magnetic flux can be penetrated deeply inside pipes because of low frequency and small induced eddy current. In this paper, the numerical results and measured results of the newly developed long-pulsed excitation system are shown. The results show the effectiveness of the proposed long-pulsed method for a large lift-off evaluation to wall thinning. [ABSTRACT FROM AUTHOR]