Search

Ionic liquids have proved to be excellent heat transfer fluids and alternatives to common HTFs used in industries for heat exchangers and other heat transfer equipment. However, its industrial utilization depends on the cost per kg of its production, to be competitive for industrial applications with biphenyl and diphenyl oxide, alkylated aromatics, and dimethyl polysiloxane oils, which degrade above 200 {\deg}C and possess some environmental problems. The efficiency of a heat transfer fluid depends on the fundamental thermophysical properties influencing convective heat transfer (density, heat capacity, thermal conductivity, and viscosity), as these properties are necessary to calculate the heat transfer coefficients for different heat exchanger geometries. In Part 1, the thermophysical properties of pure 1-ethyl-3-methylimidazolium methanesulfonate $[C_{2}mim][CH_{3}SO_{3}]$ (CAS no. 145022-45-3), (ECOENG 110), produced by BASF, under the trade name of Basionics ST35, with an assay $\geq$97% with $\leq$0.5% water and $\leq$2% chloride ($Cl^{-}$), were presented, for temperatures slightly below room temperature and up to 355 K. In this paper, we report the thermophysical properties of mixtures of [C2mim][CH3SO3] with water, in the whole concentration range, at $P$ = 0.1 MPa. The properties measured were density and speed of sound (293.15 < $T$/K < 343.15), viscosity, electrical and thermal conductivities, refractive index (293.15 < $T$/K < 353.15), and infinite dilution diffusion coefficient of the ionic liquid in water (298.15 K).

Measurements of the radius and limb brightening of the Sun provide important information about the solar atmosphere structure and temperature. The solar radius increases as the observation at radio frequency decreases, indicating that each emission originates higher in the atmosphere. Thus, different layers of the solar atmosphere can be probed by observing at multiple wavelengths. In this work, we determined the average radius and limb brightening at 100, 212, 230, and 405 GHz, using data from the Solar Submillimeter Telescope and ALMA's single-dish observations. For the first time, limb brightening values for frequencies of 212 and 405 GHz were estimated. At sub-THz frequencies, the observed limb brightening may affect the solar radius measurements. We use two different and well known approaches to determine the radius: the half-power method and the inflection-point method. We investigate how the antenna beam size and the limb brightening level, LB, can affect the radius measurements using both methods. Our results showed that the inflection-point method is the least affected by these parameters, and should thus be used for solar radius estimates at radio wavelengths. The measured average radii are 968"~$\pm$~3" (100 GHz), 963"~$\pm$~3" (212 GHz), 963"~$\pm$~2" (230 GHz), and 963"~$\pm$~5" (405 GHz). Finally, we used forward modeling to estimate the ranges of LB of the solar disk resulting in 5%-19% (100 GHz), 2%-12% (212 GHz), 6%-18% (230 GHz), and 3%-17% (405 GHz). Both radius and limb brightening estimates agree with previous measurements reported in the literature.

At subterahertz frequencies -- i.e., millimeter and submillimeter wavelengths -- there is a gap of measurements of the solar radius as well as other parameters of the solar atmosphere. As the observational wavelength changes, the radius varies because the altitude of the dominant electromagnetic radiation is produced at different heights in the solar atmosphere. Moreover, radius variations throughout long time series are indicative of changes in the solar atmosphere that may be related to the solar cycle. Therefore, the solar radius is an important parameter for the calibration of solar atmospheric models enabling a better understanding of the atmospheric structure. In this work we use data from the Solar Submillimeter-wave Telescope (SST) and from the Atacama Large Millimeter/submillimeter Array (ALMA), at the frequencies of 100, 212, 230, and 405 GHz, to measure the equatorial and polar radii of the Sun. The radii measured with extensive data from the SST agree with the radius-vs-frequency trend present in the literature. The radii derived from ALMA maps at 230 GHz also agree with the radius-vs-frequency trend, whereas the 100-GHz radii are slightly above the values reported by other authors. In addition, we analyze the equatorial and polar radius behavior over the years, by determining the correlation coefficient between solar activity and subterahertz radii time series at 212 and 405 GHz (SST). The variation of the SST-derived radii over 13 years are correlated to the solar activity when considering equatorial regions of the solar atmosphere, and anticorrelated when considering polar regions. The ALMA derived radii time series for 100 and 230 GHz show very similar behaviors with those of SST., Comment: 10 pages, 5 figure, 3 tables, 1 equation

In this paper we develop a SIR epidemiological model with parameters calculated according to existing data at the time of writing (24/03/2020); the data is from Italy, South Korea and Colombia, the model is then used to project the evolution of the COVID-19 epidemic in Colombia for different scenarios using the data of population for the country and known initial conditions at the start of the simulation., Comment: Model has been proven incorrect by actual data

We use the Monte Carlo particle physics code FLUKA (Fluktuierende Kaskade) to calculate $\gamma$-ray spectra expected from solar flare energetic ion distributions. The FLUKA code includes robust physics-based models for electromagnetic, hadronic and nuclear interactions, sufficiently detailed for it to be a useful tool for calculating nuclear de-excitation, positron annihilation and neutron capture line fluxes and shapes, as well as $\approx \; {\rm GeV}$ continuum radiation from pion decay products. We show nuclear de-excitation $\gamma$-ray line model spectra from a range of assumed primary accelerated ion distributions and find them to be in good agreement with those found using the code of Murphy et al. (2009). We also show full $\gamma$-ray model spectra which exhibit all the typical structures of $\gamma$-ray spectra observed in solar flares. From these model spectra we build templates which are incorporated into the software package Objective Spectral Executive (OSPEX) and used to fit the combined Fermi Gamma-ray Burst Monitor (GBM)/Large Area Telescope (LAT) spectrum of the 2010 June 12 solar flare, providing a statistically acceptable result. To the best of our knowledge, the fit carried out with the FLUKA templates for the full $\gamma$-ray spectrum can be regarded as the first attempt to use a single code to implement a self-consistent treatment of the several spectral components in the photon energy range from $\approx 100$s ${\rm keV}$ to $\approx 100$s ${\rm MeV}$., Comment: Accepted for publication in Solar Physics

This paper describes a collaborative educational data mining tool based on association rule mining for the continuous improvement of e-learning courses allowing teachers with similar course's profile sharing and scoring the discovered information. This mining tool is oriented to be used by instructors non experts in data mining such that, its internal operation is transparent to the user and the instructor can be focused in to the analysis of the results and make decisions about how to improve e-learning courses. (Contains 5 figures.) [Funding was provided by the Spanish Department of Research. For the complete proceedings, "Proceedings of the International Conference on Educational Data Mining (EDM) (2nd, Cordoba, Spain, July 1-3, 2009)," see ED539041.]

In this paper is developed a simple mathematical model of transient heat transfer under soil with plastic mulch in order to determine with numerical studies the influence of different plastic mulches on the soil temperature and the evolutions of temperatures at different depths with time. The governing differential equations are solved by a Galerkin Finite Element Model, taking into account the nonlinearities due to radiative heat exchange between the soil surface, the plastic mulch and the atmosphere. The model was validated experimentally giving good approximation of the model to the measured data. Simulations were run with the validated model in order to determine the optimal combination of mulch optical properties to maximize the soil temperature with a Taguchi's analysis, proving that the material most used nowadays in Colombia is not the optimal and giving quantitative results of the properties the optimal mulch must possess.