Search

Abstract Dam stability is one of the most important issues in hydraulic engineering. Microfractures and damage commonly occur during impoundment, which might lead to serious dam problems. In this study, based on the engineering background of the Sanhekou hydropower station, microseismic monitoring and numerical simulation were employed to systematically investigate the microfracture and damage characteristics of the dam body. First, the microseismic monitoring system was established to capture the microfractures inside the dam. The results indicated that the rise in water level elevation has a significant effect on the microfracture and damage characteristics of the dam body, especially during the early stage of impoundment. This can be reflected by the variation in the derived source parameters, i.e., the b value, daily energy release, daily apparent stress and daily apparent volume. In addition, the failure mode of the microfractures could be determined by using the E S /E P value of microseismic events and the moment tensor inversion method. The cracking orientation of the failure surfaces could also be determined by the moment tensor inversion method. Subsequently, numerical simulation was conducted where the initial damage of the dam was considered by integrating the microseismic monitoring data. The simulation results suggested that dam deformation under impoundment considering microseismic feedback agrees well with the real field measured results. The stress level of the dam toe was larger than that of the dam heel, and both the dam toe and dam heel were under compression before impoundment. However, with increasing water level elevation, the stress status of the dam heel area changes from compression to tension. The findings in this study will provide a better understanding of the damage and failure mechanism of dams during impoundment, which might be helpful for the design and support of dams in hydropower stations.

In this paper, a novel transformer structure is proposed in order to manufacture a high-power active filtering device. The novel transformer structure contains one primary and multiple secondary windings. The system configuration and compensation principle are addressed in detail. The fundamental magnetic flux compensation in the case of the transformer with multiple secondary windings is fulfilled. In addition, a three-phase active power filter topology consisting of three independent transformers with multiple secondary windings is presented so that the filter can run under unbalanced loads. The parameters of hysteresis current control are also analyzed in detail. A simple and practical fundamental detecting approach is discussed. Transient response and fault protection schemes are explained. A set of automatic three-phase active power filtering devices has been constructed and operated in the field. The field test results verify the validity of the novel transformer structure and the active power filtering system. [ABSTRACT FROM AUTHOR]

In this paper, a novel practical principle of series hybrid active power filter based on the fundamental magnetic flux compensation (FMFC) of a series transformer is proposed. In the active power filter, the fundamental current component of power utility is detected and tracked to produce a fundamental compensation current, which is injected into the secondary winding. According to the law of superposition, when the injected fundamental current and the fundamental current component of the power utility satisfy the FMFC, the series transformer can really exhibit very low impedance to fundamental and naturally magnetizing impedance to harmonics. As a result, the series hybrid active power filter with FMFC really acts as a "harmonic isolator". The current control scheme and fundamental detecting method are analyzed. The validity of the novel principle and excellent filtering characteristics are verified by the experimental results of the two kinds of typical harmonic-producing loads. [ABSTRACT FROM AUTHOR]