Search

Field-effect transistors (FETs) based on two-dimensional materials (2DMs) with atomically thin channels have emerged as a promising platform for beyond-silicon electronics. However, low carrier mobility in 2DM transistors driven by phonon scattering remains a critical challenge. To address this issue, we propose the controlled introduction of localized tensile strain as an effective means to inhibit electron-phonon scattering in 2DM. Strain is achieved by conformally adhering the 2DM via van der Waals forces to a dielectric layer previously nanoengineered with a gray-tone topography. Our results show that monolayer MoS2 FETs under tensile strain achieve an 8-fold increase in on-state current, reaching mobilities of 185 cm²/Vs at room temperature, in good agreement with theoretical calculations. The present work on nanotopographic grayscale surface engineering and the use of high-quality dielectric materials has the potential to find application in the nanofabrication of photonic and nanoelectronic devices. Improving the performance of 2D transistors is essential to enable their future application for beyond-silicon electronics. Here, the authors report a method to induce localized tensile strain in monolayer MoS2 transistors, leading to enhanced electron mobilities up to 185 cm2/Vs and an 8-fold increase of the on-state current densities. [ABSTRACT FROM AUTHOR]

Plasma medicine is a field that utilizes reactive species generated from atmospheric low-temperature plasmas for applications such as sterilization, blood coagulation, and cancer therapy. Commercial plasma devices are available for wound healing, but research on the chemical modifications induced by these plasmas is scarce. This study explores the chemical modifications in hemoglobin when exposed to a helium plasma dielectric barrier discharge, with the aim of explaining the potential mechanisms through which it contributes to blood coagulation and enhances wound healing. Optical microscopy of cold atmospheric plasma (CAP) treated whole capillary blood showed an increase in red blood cell (RBC) size and the formation of rouleaux structures. The treatment of whole blood leads to hemolysis of RBCs and the release of intracellular protein content. We then treated purified hemoglobin protein at physiological concentrations, which led to the formation of aggregates that could be observed using ion mobility mass spectrometry (IM–MS), size exclusion chromatography, and optical microscopy. The aggregates formed fibril-like structures as observed using atomic force microscopy. The formation of hemoglobin aggregates is hypothesized to be the result of new intermolecular interactions formed following the CAP-mediated protein oxidation. We studied the changes to hemoglobin structure after treatment with a CAP using high-resolution MS and found that the hemoglobin subunits are oxidized with the addition of at least 4 oxygen atoms each. The intact tetrameric hemoglobin structure remains unchanged; however, the monomeric and dimeric proteins adopt a more compact structure, as observed by IM–MS. We propose that CAP treatment of fresh blood leads to hemolysis, and that the extracellular protein, primarily hemoglobin, is oxidized leading to the formation of aggregates. [ABSTRACT FROM AUTHOR]

Rationale: Secondary-electrospray ionization (SESI) coupled with high-resolution mass spectrometry is a powerful tool for the discovery of biomarkers in exhaled breath. A primary electrospray consisting of aqueous formic acid (FA) is currently used to charge the volatile organic compounds in breath. To investigate whether alternate electrospray compositions could enable different metabolite coverage and sensitivities, the electrospray dopants NaI and AgNO3 were tested. Methods: In a proof-of-principle manner, the exhaled breath of one subject was analyzed repeatedly with different electrospray solutions and with the help of a spectral stitching technique. Capillary diameter and position were optimized to achieve proper detection of exhaled breath. The detected features were then compared using formula annotation. Using an evaporation-based gas standard system, the signal response of the different solutions was probed. Results: Principal component analysis revealed a substantial difference in features detected with AgNO3. With silver, more sulfur-containing features and more unsaturated hydrocarbon compounds were detected. Furthermore, more primary amines were potentially ionized, as indicated by van Krewelen diagrams. In total, twice as many features were unique to AgNO3 than for other electrospray dopants. Using gas standards at known concentrations, the high sensitivity of FA as a dopant was demonstrated but also indicated alternate sensitivities of the other electrospray solutions. Conclusions: This work demonstrated the potential of AgNO3 as a complementary dopant for further biomarker discovery in SESI-based breath analysis. [ABSTRACT FROM AUTHOR]

We doped nitrogen into monolayer graphene using reactive nitrogen species from a dielectric barrier discharge (DBD). After 30 s of treatment, the graphene monolayer had a moderate degree of damage (ID/IG = 1.2) and an increase in the N‐atom (pyrrolic) and O‐atom (mixed) content. During long treatment times (20 min), the treated area increased radially and the graphene was destroyed. Overall, the N‐atom content increased with increasing operating voltage of the DBD source. When the graphene was treated with only neutral reactive nitrogen species, the N‐atom content and type remained unchanged. Therefore, we hypothesize that the primary reactive species resulting in pyrrolic N‐doping from the DBD are neutrals such as N(4S) and possibly N(2P). [ABSTRACT FROM AUTHOR]