Search

In the present work, inexpensive and commercially available diethyltriamine pentaacetic acid (DTPA) was used as an initiator to catalyze the N-formylation reaction of CO2 with amines via the construction of C-N bonds in the presence of xanthone as the photosensitizer and PhSiH3 as the reducing agent. After a systematic study of various factors, the optimal conditions for the photocatalytic reaction were obtained: 2.5 mmol of amine, 2.5 mmol of PhSiH3, 10 mol% of DTPA, 20 mol% of xanthone, 1 mL of dimethylsulfoxide (DMSO), atmospheric pressure, and 35 W UV lamp irradiation for 48 h. Under the optimal conditions, the catalyst system afforded high performance for the N-formylation of amines (primary and secondary amines) and CO2, and the yields of the N-formylated products of dialkylamines were above 70%. Further studies exhibit that the catalytic system has a wide scope of substrate applications. For various alicyclic secondary amines, heterocyclic secondary amines, aliphatic primary amines, and aromatic primary amines, the corresponding N-formylation products can be obtained efficiently. In addition, the catalyst can be recycled by simple precipitation and filtration. After five cycles of recycling, there was no significant change in the catalytic and structural properties of DTPA. Finally, a possible reaction mechanism is proposed. [ABSTRACT FROM AUTHOR]

The reduction of CO2 is an important method to produce chemicals such as methanol, formic acid, formaldehyde, etc. In general, the reduction of CO2 is carried out at high temperatures and pressures with precious metals as catalysts, which is not favorable for industrial procedures. Thus, it will be very useful if researchers can find cost-effective catalysts for industrial application in CO2 reduction. In this work, commercially available ethylenediaminetetraacetic acid (EDTA) was tested as a cheap, non-toxic, and recyclable catalyst to initiate the N-carbonylation reaction of CO2 with amines. After screening various reaction parameters, including temperature, pressure, time, solvent, and reducing agent, the optimal reaction conditions were obtained: 80 °C, 2 MPa, 6 h, 50 mmol% catalyst dosage, 1 mL DMSO, and 1:1 molar ratio of amine to reducing agent. Notably, further studies confirmed that EDTA could also be effective for N-formylation even under ambient conditions (0.1 MPa and room temperature). The suitability of the catalyst for 26 kinds of substrates (including aliphatic amines, aromatic amines, and alicyclic amines) and its reusability were also investigated, with satisfactory results. Scale-up research has been performed effectively with a high conversion of amine (83%) to obtain the mono-formylated product selectively. Finally, the mechanism of the reaction between amine and CO2 has been proposed via control experiments and compared with results in the literature. [ABSTRACT FROM AUTHOR]

Ammonium, imidazole, or pyridinium functionalized β-cyclodextrins (β-CDs) were used as efficient one-component bifunctional catalysts for the coupling reaction of carbon dioxide (CO2) and epoxide without the addition of solvent and metal. The influence of different catalysts and reaction parameters on the catalytic performance were examined in detail. Under optimal conditions, Im-CD1-I catalysts functionalized with imidazole groups were able to convert various epoxides into target products with high selectivity and good conversion rates. The one-component bifunctional catalysts can also be recovered easily by filtration and reused at least for five times with only slight decrease in catalytic performance. Finally, a possible process for hydroxyl group-assisted ring-opening of epoxide and functionalized group- induced activation of CO2 was presented. [ABSTRACT FROM AUTHOR]