Search

Coating products are widely used for the interior decoration of residential property. However, there is growing concern regarding their odor emissions and their impact on indoor air quality (IAQ). Most manufacturers and government agencies set odor intensity limits to control the odor of coating products, including their raw materials. However, it is difficult to determine product performance by means of their odor intensity index. Although evaluating odor intensity requires odor assessors to distinguish between different intensity levels, low consensus and reproducibility represent challenges that are difficult to avoid. As the odor concentration index only requires odor assessors to ascertain whether the odor is felt or not, the reproducibility of the evaluation results is relatively better. Moreover, suitable methodologies for determining odor concentrations in volatile coating product emissions have rarely been reported. Therefore, establishing an evaluation method for odor concentration of coating products and exploring its key influencing factors should bridge this gap. We examined the influence of the airbag material on the recovery rate of typical volatile organic compounds (VOCs) using direct injection by GC-MS and established that their adsorption effects were in the order: PET > PVF > PTFE. We then explored the influences of the sample curing and odor emission times on odor concentration. The solvent-based and water-based coatings reached equilibrium after 8 h and 16 h curing, respectively, and after 8 h and 12 h odor emission, respectively. The odor concentrations of real coating samples were measured and compared against their odor intensities. The odor concentration method more accurately and reliably discriminated coating products than the odor intensity approach. Thus, to assist manufacturers in improving coating formulations to reduce the odor impact of coating products, we used headspace gas chromatography to determine the odor substances in water- and solvent-based coatings and analyzed the odor contribution of various volatile compounds using the odor activity value (OAV) method. Butyl acetate, ethylbenzene, and 1-methoxy-2-propyl acetate were the key odorants in solvent-based coatings while 1-butanol, ethylbenzene, and butyl acetate were the key odorants in water-based coatings.

As one of the major sources of volatile pollutants in indoor air, gaseous emissions from adhesives during interior decoration have attracted increasing concern. Identifying major volatile pollutants and the risk in adhesive gaseous emissions is of great significance, but remains rarely reported. In the present research, we assessed the major volatile pollutants emitted from white emulsion adhesive and silicone adhesive samples (n = 30) from three aspects: chemical composition, odor and health risk contributions. The results showed that a total of 21 volatile pollutants were detected. Significantly, xylene was the most concentrated compound from white emulsion adhesives, accounting for 45.51% of the total concentrations. Butanone oxime was the most concentrated compound in silicone adhesives, accounting for 69.86% of the total concentrations. The trends in odor concentration (evaluated by the odor activity value method) over time were well correlated with the total chemical concentrations. Xylene (58.00%) and butanone oxime (76.75%) showed the highest odor contribution, respectively. Moreover, from an integrated perspective of chemical emissions, odor and health risk contributions, xylene, ethylbenzene, ethyl acetate and benzene were identified as the key volatile pollutants emitted from the white emulsion adhesives, while butanone oxime, butanone, and ethanol were the key volatile pollutants emitted from the silicone adhesives. This study not only identified the key volatile pollutants but also provided characteristics of odor and health risks of gas emitted from adhesives.