Search

This paper presents a design method of a suspension controller with an adaptive feedforward algorithm for ride comfort enhancement and motion sickness mitigation. Recently, it was shown that motion sickness is caused by combined heave and pitch motions of a sprung mass within the range of 0.8 and 8 Hz. For this reason, it is necessary to design a suspension controller for the purpose of reducing the heave and pitch vibration of a sprung mass within this range. To represent the heave acceleration and the pitch rate of a sprung mass, a 4-DOF half-car model is adopted as a vehicle model. For easy implementation in a real vehicle, a static output feedback control is adopted instead of a full-state one. To reduce the heave acceleration of a sprung mass for ride comfort enhancement, a linear quadratic SOF controller is designed. To reduce the pitch rate of a sprung mass for motion sickness mitigation, a filtered-X LMS algorithm is applied. To validate the method, simulation on vehicle simulation software is conducted. From the simulation results, it is shown that the proposed method is effective for ride comfort enhancement and motion sickness mitigation. [ABSTRACT FROM AUTHOR]

Featured Application: Path Tracking Control for Autonomous Driving. This paper presents a method to design a path tracking controller with a constraint on tire slip angles under low-friction road conditions. On a low-friction road surface, a lateral tire force is easily saturated and decreases as a tire slip angle increases by a large steering angle. Under this situation, a path tracking controller cannot achieve its maximum performance. To cope with this problem, it is necessary to limit tire slip angles to a value where the maximum lateral tire force is achieved. The most commonly used controllers for path tracking, linear quadratic regulator (LQR) and model predictive control (MPC), are adopted as a controller design methodology. The control inputs of LQR and MPC are front and rear steering angles and control yaw moment, which have been widely used for path tracking. The constraint derived from tire slip angles is imposed on the steering angles of LQR and MPC. To fully verify the performance of the path tracking controller with the constraint on tire slip angles, a simulation is conducted on vehicle simulation software. From the simulation results, it is shown that the path tracking controller with the constraint on tire slip angles presented in this paper is quite effective for path tracking on low-friction road surface. [ABSTRACT FROM AUTHOR]