Search

Solid recovered fuel (SRF) residue, which is leftovers from the SRF manufacturing process, usually is discarded in landfill because of its low heating value and high ash and moisture content. However, it could be used as a fuel after mechanical and biological treatment. Gasification experiments were conducted on treated SRF residue (TSRFR) to assess the viability of syngas production. Efforts were also made to improve the gasification performance by adding low-cost natural minerals such as dolomite and lime as bed material, and by blending with biomass waste. In the case of additive mineral tests, dolomite showed better performance compared to lime, and in the case of biomass blends, a 25 wt% pine sawdust blend with TSRFR showed the best performance. Finally, as an appropriate condition, a combined experiment was conducted at an equivalence ratio (ER) of 0.2 using a 25 wt% pine sawdust blend with TSRFR as a feedstock and dolomite as the bed material. The highest dry gas yield (1.81 Nm3/kg), with the highest amount of syngas (56.72 vol%) and highest lower heating value (9.55 MJ/Nm3) was obtained in this condition. Furthermore, the highest cold gas efficiency (48.64%) and carbon conversion rate (98.87%), and the lowest residue yield (11.56%), tar (0.95 g/Nm3), and gas pollutants content was observed.

Proper treatment and careful management of sewage sludge are essential because its disposal can lead to adverse environmental impacts such as public health hazards, as well as air, soil, and water pollution. Several efforts are being made currently not only to safely dispose of sewage sludge but also to utilize it as an energy source. Therefore, in this study, initiatives were taken to valorize sewage sludge cake by reducing the moisture content and increasing the calorific value by applying a hydrothermal treatment technique for efficient energy recovery. The sludge cake treated at 200 °C for 1 h was found to be the optimum condition for hydrothermal carbonization, as, in this condition, the caloric value of the treated sludge increased by 10% and the moisture content removed was 20 wt.%. To recover energy from the hydrothermally treated sludge, a gasification technology was applied at 900 °C. The results showed that the product gas from hydrothermally treated sludge cake had a higher lower heating value (0.98 MJ/Nm3) and higher cold gas efficiency (5.8%). Furthermore, compared with raw sludge cake, less tar was generated during the gasification of hydrothermally treated sludge cake. The removal efficiency was 28.2%. Overall results depict that hydrothermally treated sewage sludge cake could be a good source of energy recovery via the gasification process.

This study applied oxygen-enrichment conditions to remove tar (the main problem in biomass gasification) and increase gasification efficiency. Experiments on oxygen-enrichment conditions were conducted at oxygen concentrations of 21%, 25%, 30%, and 35% in oxidants. This was expected to increase the partial oxidation reaction in gasification reactions, thus leading to thermal decomposition of tar in producer gas. The decomposed tar was expected to be converted into syngas or combustible gases in the producer gas. The results were as follows: Tar-reduction efficiency was 72.46% at 30% oxygen enrichment compared to the standard 21% enrichment condition. In addition, the concentrations of syngas and combustible gases in the producer gas tended to increase. Therefore, the 30% oxygen-enrichment condition was optimal, resulting in 78.00% for cold gas efficiency and 80.24% for carbon conversion efficiency. The application of oxygen enrichment into the lab-scale gasification system clearly reduced the concentration of tar and tended to increase some indexes of gasification efficiency, thus suggesting the usefulness of this technique in large-scale biomass gasification operations.